|
|
Afrikaans /
في الصفحة /
български /
中国 /
臺灣 /
čeština/
Dansk /
Deutsch /
Ελληνικά /
Español /
Filipino /
Français /
עברית /
Magyar /
Italiano /
日本語 /
한국어 /
Nederlands /
Norsk /
Polskie /
Português /
Română /
Pусский /
Suomalainen /
Svenska /
ภาษาไทย /
Türkçe |
Back to OSCAR Installation
OSCAR needs to set up a folder to store your data in. Click OK to accept the recommended folder or No to select an alternative folder.
If you have previously used SleepyHead, OSCAR can migrate your SleepyHead data (including your settings and preferences) into the new OSCAR data folder. Select OK for OSCAR to copy your SleepyHead data or else select No.
If you select No, Oscar will start and take you to the profile creation page. You will then be able to import your data from an SD card. See Running OSCAR for the first time.
Note that you can only migrate your SleepyHead data at this time. You can copy the raw data (no settings or preferences) later, but it's not so easy and is only recommended for advanced users. See #Copying SleepyHead data (Advanced users).
If you select OK OSCAR will then open a file selector window, where you can locate and select your SleepyHead data folder. OSCAR will then copy all the data across to the new OSCAR data folder, with a bar chart to mark its progress (this can take some little while). Note that the SleepyHead data is copied so the original data stays in place and you can still use it with SleepyHead if you wish.
On completion of the data migration, you are ready for review the data migrated from SleepyHead, or set set up a new profile. See Running OSCAR for the first time
Back to OSCAR Installation
Donate to Apnea Board