RE: Machine Settings Display
(03-20-2018, 06:39 PM)JesseLee Wrote: The charts correspond to the actual settings of min 4. All the data seems to be correct elsewhere. Have you ever had your min pressure at 7?
I would suggest that you unmount and pull your SD card out of the computer. Close all programs and restart the system. And try again.
It's now a day later and Pmin is reading 4 under Machine Statistics. So it was only wrong for one night.
RE: Machine Settings Display
(03-21-2018, 08:07 AM)Sleeprider Wrote: I would go ahead and check the machine settings and perhaps even set the minimum ramp pressure to 4. Sleepyhead shows ramp off, but I would look at the physical settings.
I checked it on the machine and Ramp is Off.
RE: Machine Settings Display
(03-21-2018, 12:52 PM)Sleep2Snore Wrote: Is there anything wrong?
My machine when it first starts, starts off at 4 and very quickly heads up to it minimum set pressure.
I have ramp and EPR off. But it does start at 4 and ramp up very quickly and never comes back below minimum pressure unless I stop it for comfort break. Or am I missing something?
I don't find anything wrong other than this strange Pmin reading.
I watch the machine start off each night. It quickly steps up to Pmin and then goes slowly higher. I stop watching and go to sleep while it's still at 4.
RE: Machine Settings Display
(03-20-2018, 06:39 PM)JesseLee Wrote: Have you ever had your min pressure at 7?
Yes. On the previous day. But I changed it to 4 over 24 hours before the bad reading occurred. I suppose that, somehow, this must be the key. But it's hard to imagine how since surely it would perform all the readings together at the same time.
RE: Machine Settings Display
Thanks to everyone who tried to help. I think that this issue will just have to dangle.
RE: Machine Settings Display
(03-21-2018, 04:38 PM)grokJim Wrote: (03-20-2018, 06:39 PM)JesseLee Wrote: Have you ever had your min pressure at 7?
Yes. On the previous day. But I changed it to 4 over 24 hours before the bad reading occurred. I suppose that, somehow, this must be the key. But it's hard to imagine how since surely it would perform all the readings together at the same time.
I'm not real sure why sleepyhead still displayed the min 7. I was thinking that sleepyhead didn't refresh the data in that table and as a result displayed the min 7. But it's good now so carry on! :-)
Jesse