Oscar Bug [Climate control & patient access]

[Osiris357]

Bonjour here are the screenshots you wanted me to post. Not a big deal just thought I'd point it out


[attachment=18647]

Climate Control says "manual" when it's actually in "auto" mode on the machine. It said "Auto" when I had it in manual mode on the machine. Patient access should say "yes" not "no". Before I put the essential setting on the machine on "plus" it always said "yes". I switched it to "plus" and now it says "no" 

This is the version of Oscar 


[attachment=18650]

[GuyScharf]

Climate Control says "manual" when it's actually in "auto" mode on the machine. It said "Auto" when I had it in manual mode on the machine. Patient access should say "yes" not "no". Before I put the essential setting on the machine on "plus" it always said "yes". I switched it to "plus" and now it says "no"

The incorrect "climate control" is fixed for the next release.

So essential setting of Plus/no is reported as Patient access? I will log that and we'll take care of it in the future.

[Osiris357]

Guyscharf, that is correct. Ok sounds good

[pholynyk]

Good catch, Osiris357 - I always assumed that Patient Access referred to Clinician mode - Perhaps we should relabel that line to 'Essential Data' - (which is actually Minimal Data) with the choices being 'On' and 'Plus' , as on the machine.

[Osiris357]

I thought that also until I changed it to plus and noticed the change in Oscar.

I changed it back and forth a few times to make sure it wasn’t a one off glitch before saying anything.

[Gideon]

Thanks Osiris,
That brought the issue to multiple people and to to the right people and in a manner that they could see it and understand it. Well done.

[Osiris357]

I was being rushed out the door when I first brought it up to you so I picked the wrong option. I’ll make sure to post things like this in the software forum from now on. I don’t think I will though since nothing else sticks out and everything that does is already being addressed. Except for the ability to switch between 2 different chart configurations with a click of a button and having the default configuration setup for what’s needed to help people. That may already have been addressed though and I haven’t seen it.