Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Performance of my Resmed Airsense A-10 Autoset
#1
Performance of my Resmed Airsense A-10 Autoset
Hi Friends,

After purchase of new A10 Autoset last month on the advice of forum members, I did not post about the performance since I was facing teething problems which since appear to be overcome and hence this new post dealing with the performance.

During the interim I also changed my mask to N20 which also now appears to be working fine.

I post a couple of overview charts alongwith a chart of usage statistics.

I would request members to please give their comments on the performance of the machine and if some change is required . Thx.

   

   

   
Post Reply Post Reply
#2
RE: Performance of my Resmed Airsense A-10 Autoset
Your doing great on the Resmed machine your AHI is less than 2 our target, often much less, at this point I do not see any reason to recommend any changes to the settings. How do you feel are you sleeping well ?


I do see your leaks are quite high, are you breathing through your mouth ? A daily chart will give us a better understanding on that
Post Reply Post Reply
#3
RE: Performance of my Resmed Airsense A-10 Autoset
Yes, I do have to breathe thru the mouth immediately after lying down and putting on the mask since then I find some obstruction in the nose making it difficult to breathe . However after adjusting facial position/mask as also giving some initial breathing support thru mouth I find the normal nose breathing continuing.

I also note that the initial part of my sleep is getting disturbed 4-5 times for going to the bathroom. I continue to suffer from slight morning headaches and do not feel as fresh as one should.

Pl indicate the date for which the leak chart is required. Thx.
Post Reply Post Reply
#4
RE: Performance of my Resmed Airsense A-10 Autoset
(09-15-2019, 02:29 AM)galuta Wrote: I also note that the initial part of my sleep is getting disturbed 4-5 times for going to the bathroom. I continue to suffer from slight morning headaches and do not feel as fresh as one should.

Pl indicate the date for which the leak chart is required. Thx.

Hi galuta,
Your AHI reading is very good, but as you now know, a low reading doesn’t always reflect how we feel. Sad

A lot of men suffer with having to use the bathroom frequently.  Watch you fluid intake close to bedtime, and if this doesn’t settle down for you, you might want to see a urologist.  

Also, be sure your High Blood Pressure is under control.  If your readings are too high, that could be one reason for morning headaches.  Hopefully, the headaches will lessen for you.

If you would post a couple charts of the daily page from OSCAR, as jaswilliams suggests, we could have a clearer look at your graphs.  Follow the link below for organizing a chart.

Include the left sidebar, and eliminate the calendar and pie chart.  The graphs to include:  Events,
Flow rate, pressure, leak rate and snores.

Post 2 or 3 recent charts from different days.
OpalRose
Apnea Board Administrator
www.apneaboard.com

_______________________
OSCAR Chart Organization
How to Attach Images and Files.
OSCAR - The Guide
Soft Cervical Collar
Optimizing therapy
OSCAR supported machines
Mask Primer



INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE.  ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA.  INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#5
RE: Performance of my Resmed Airsense A-10 Autoset
AHI looks very good, but seeing a daily Details chart would be much more helpful. Regarding the stuffed nose I have been dealing with persistent nasal congestion this summer and would often have to exhale orally to move enough air. I recently started using generic Flonase, and the congestion has completely resolved. I'm sleeping much better and am more comfortable. If your congestion might be related to allergy, this may be a solution.
Sleeprider
Apnea Board Moderator
www.ApneaBoard.com

____________________________________________
Download OSCAR Software
Soft Cervical Collar
Optimizing Therapy
Organize your OSCAR Charts
Attaching Files
Mask Primer
How To Deal With Equipment Supplier


INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#6
RE: Performance of my Resmed Airsense A-10 Autoset
1. Yes, blood pressure of course could be one of the causes for the headache and for which purpose I continue to be on medication. Hopefully this would be sorted out in near future. Here I am only trying to eliminate the possibility of OSA being a possible cause.

2. I was earlier under treatment for nasal congestion which persisted for quite some time a couple of years back. Now it seems to be back though in a much milder form. If it persists then I shall of course have to take medication.

3. I enclose some Daily Charts as adviced.

I thank the members for their concern and prompt replies.

   

   

   
Post Reply Post Reply
#7
RE: Performance of my Resmed Airsense A-10 Autoset
galuta,
Scroll down to the bottom of daily page, under the last graph, to the left.  Click on the drop down box and be sure all the flags are on.  They should be green, not red.

I’m looking for the Obstructive flag, as I don’t see it showing up on the event graph.(See red arrow)

You may need a little higher pressure to help with Obstructives, and if you can do without, I would turn the ramp off.

[attachment=15512]
OpalRose
Apnea Board Administrator
www.apneaboard.com

_______________________
OSCAR Chart Organization
How to Attach Images and Files.
OSCAR - The Guide
Soft Cervical Collar
Optimizing therapy
OSCAR supported machines
Mask Primer



INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE.  ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA.  INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#8
RE: Performance of my Resmed Airsense A-10 Autoset
OA flag switched on and related graphs are as below.  Graphs have been posted for additional dates also.

I wish to point out that in the beginning of the month I was having serious mask issues which, however, are now sorted out ( I am pointing this out in case the mask has any effect on the obstructives).

Shall be glad of help now.


Attached Files Thumbnail(s)
                   
Post Reply Post Reply
#9
RE: Performance of my Resmed Airsense A-10 Autoset
I think your minimum pressure needs to be at least 9.0 cm. I base this on the fact you consistently reach 11-12 on your 95% pressure (IPAP). With EPR full time at 3 this would make your starting pressure 9/6 which is completely reasonable, and should help you to kick some of the flow limitations out. The other alternative is bilevel with a higher pressure support. Your therapy "looks" good but you have very persistent flow limits that are the driver of your pressure. Rather than wait for the flow limits to raise your pressure, you just need to start higher. If you had a bilevel machine I could see you with a pressure support of 4 or 5, but would still want to see a minimum EPAP pressure of 8.
Sleeprider
Apnea Board Moderator
www.ApneaBoard.com

____________________________________________
Download OSCAR Software
Soft Cervical Collar
Optimizing Therapy
Organize your OSCAR Charts
Attaching Files
Mask Primer
How To Deal With Equipment Supplier


INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#10
RE: Performance of my Resmed Airsense A-10 Autoset
I have just purchased my A10 Autoset after discussing in the forum and would therefore like to continue with it.

Pl do confirm whether to change the min pressure settings to 9. EPR and Ramp etc to continue unchanged.

Any other suggestions pl.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  [Equipment] Higher AHI Readings on AirSense 11 than AirSense 10 Bmck8381 3 351 11-20-2024, 11:49 AM
Last Post: G. Szabo
Angry ResMed AirSense 10 Burn Smell bsullivan 113 37,619 11-19-2024, 10:16 AM
Last Post: Sleepster
  [Equipment] ResMed AirSense 11 compatible pulse oximeters timtaller 120 52,668 11-18-2024, 02:21 PM
Last Post: Crimson Nape
  Resmed Airsense 11 Sleepyrob54 5 244 11-16-2024, 03:53 PM
Last Post: Mecate13
  Airsense 11 Autoset oximetry data not showing up in OSCAR Sleepy Willy 7 296 11-10-2024, 03:10 PM
Last Post: e727147
  Resmed Airsense 11 Random SD Card Issues ineedsomesleep 5 287 11-09-2024, 01:30 PM
Last Post: sauerkraut
  Question about Resmed Airsense 11 NICK220 8 739 11-06-2024, 12:44 PM
Last Post: NICK220


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.