Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.
Login or Create an Account
I was optimistic - and the CPAP settings have definitely improved the quality of my sleep - but the last couple nights have shown 50% and 76% large leak respectively, even after adjusting the mask as instructed again last night.
If anyone has any further advice or suggestions, I would be very grateful.
I've attached my last night's record screenshot for reference.
It's all about the leaks. Your pressure looks to be working well with the Autoset mode and EPR. It may be time to start trying some alternative mask models.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
OK this was with the Simplus correct? Which sizes of cushions have you tried? You might get a different size for the Simplus. Maybe wash the cushion you have in hot water and Dawn dish soap or similar. Scrub the silicone of the cushion lightly while in the soapy water and rinse it. Then either air dry or wipe it off afterwards. And be certain the mask sits lower on the nasal bridge. That's where both of my Simplus and Vitera would leak.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
