Resmed setting not matching SleepyHead
So I went to the doc yesterday and gave them the SD card from my Resmed AirSense 10. She thought that we could increase the minimum pressure. After I got home and put the SD card back in the settings showed the higher minimum pressure. But when I looked at the data in Sleepyhead this morning it showed the old minimum pressure and did not show any changes in the "Changes to Perscription" section on the statistics page.
RE: Resmed setting not matching SleepyHead
(04-20-2018, 03:49 PM)Albercook Wrote: So I went to the doc yesterday and gave them the SD card from my Resmed AirSense 10. She thought that we could increase the minimum pressure. After I got home and put the SD card back in the settings showed the higher minimum pressure. But when I looked at the data in Sleepyhead this morning it showed the old minimum pressure and did not show any changes in the "Changes to Perscription" section on the statistics page.
Sometimes Sleepyhead does not show the prescription change until the following day (If the card was put in the machine after midday) Sleepyhead takes the settings from the First session data which the machine will automatically write at Midday.
The charts should follow the revised data though. Post the daily chart here and we can soon tell if the settings changed from the pressures shown in the graph
Jason
RE: Resmed setting not matching SleepyHead
Thanks. The chart definitely shows the change. Will see if sleepyhead catches up. Thanks
