Sleep Master wireless XPAP data transfer

[Jack_Russell_Fan]

Thanks for your reply. I did understand what this meant, not sure why it was brought up.

I have redone the set up and still no connection in station mode. I can connect in access point mode. My card is model number: SD-R008GR7AL01, could this be the problem? I have the setting set to SRS1. Is this OK for my Respironics 60 series?

Thanks again for all your help.

Your Flashair is one of the compatible models, and your XPAP machine settings are correct, if you meant PRS1!

What is the distance between the Flashair in your XPAP and your router?

Tom

My router is about 15 Ft. from my XPAP.

I uploaded a new version, v2.0.1.23, yesterday to sleepmaster.org.

You might want to try it. Also. before you uninstall your current version, select the "Redo setup for all users option" and then close the program and uninstall the old version. Install the new version.

Tom

[cholo]

Your Flashair is one of the compatible models, and your XPAP machine settings are correct, if you meant PRS1!

What is the distance between the Flashair in your XPAP and your router?

Tom

My router is about 15 Ft. from my XPAP.

I uploaded a new version, v2.0.1.23, yesterday to sleepmaster.org.

You might want to try it. Also. before you uninstall your current version, select the "Redo setup for all users option" and then close the program and uninstall the old version. Install the new version.

Tom

Thanks sooooo much!!
This update worked for me!!

[Luxsit5280]

I have an AirCurve 10 VAuto. I assume that this software would work using Generic Mode? I have to get the SD Card right?

[Jack_Russell_Fan]

I have an AirCurve 10 VAuto. I assume that this software would work using Generic Mode? I have to get the SD Card right?

Sleep Master has not been tested with the Aircurve 10, but either the AS10 option or the generic should work. Let me know how it goes!

Tom

[Jack_Russell_Fan]

The newest version v2.0.1.31 now supports the Air Curve 10.

http://sleepmaster.org

Tom

[WSHenry]

Tom,

Thank you for the incremental improvements in this software utility. Your hard work is appreciated!

[Jack_Russell_Fan]

Tom,

Thank you for the incremental improvements in this software utility. Your hard work is appreciated!

WSHenry, you are certainly welcome!

Tom

[ClarkK]

Awesome that this is available. Just ordered a compatible card and am looking forward to setting this up. Will let everyone know how it goes!

[ClarkK]

I used the step by step instructions posed in this thread (thanks sgearhart!) and was working in station mode on my first try! And that's through 3 or 4 walls and 2 rooms away. I'm definitely a fan -- thx Tom for developing this!

[AlanE]

I ran into an issue that I haven't been able to find a post on.

SM will find the card and connect to it fine but when it goes to copy the data I get this: