Notification says "9 sessions imported" but only 1 showing up

[Plmnb]

Ok, what goofy thing have I done now?

I put my SD card in my computer just now after a nap.  There should be the sessions from last night as well.  But for some reason only a session from last night, about 1/2 an hour in length is showing up.  After the import is complete I get a little notification window that says 9 sessions imported.  What gives?

Thank you!

[Crimson Nape]

If you just inserted your SD card now, all it will (or should) get is Summary data.  Actual detailed data requires the card to be in the CPAP while an active sleep session is in progress.

[sheepless]

similarly, if you already downloaded data once yesterday / last night, additional sessions from yesterday / last night won't transfer until you purge previously transferred data from yesterday / last night.

for developers, I'm not sure if it's the same thing & I have not confirmed / documented it much, but I've been noticing occasional differences between # of sessions reported as downloaded compared to # sessions listed or graphed.

[sawinglogz]

Also, if your settings are skipping short sessions (< 5 minutes) you'll see fewer sessions than were imported from the SD card.

[Plmnb]

I swear card was in machine. Number of sessions though has been an issue, I usually just shrug them off.

Could be related to length of session although the one that did show up this afternoon was fairly short. I gotta check.

[Crimson Nape]

There seems to be a problem if you have a break less than 3 minutes between sessions on a ResMed.