Help with OSCAR screenshots

[artsyuno]

I want to post charts to get some guidance, but I can't figure out how to get them to resize so that all the necessary charts will fit on the screen.  I'm on a Mac.  Can someone explain?  I tried resetting the graphs and heights and that did nothing.  Thanks!

[OpalRose]

We don't need to see all the graphs.  For starters, the following graphs are needed:  Events, Flow Rate, Pressure, Flow Limitation and Leak Rate.  iIf we need to see more, we'll ask.  

Follow these directions for setting up a chart and taking a Screenshot to upload here:

Make sure that your display is set to the Standard view, your graphs are in the default order, and all graphs are of the same size. 
 If not:
   * To reset the Default Graph Order:  Go to (View > Reset Graphs > Standard)
  
Note: Only the Events graph should be pinned.

   * To reset Graph Heights:  Go to (View > Reset Graphs Heights)

1. Resize the Daily screen's left panel's width, so each channel parameter only uses one line and does not wrap the data.  This allows more information to be displayed.


2. Make sure you are at the top of the Daily screen and have not scrolled down.  Also, make sure you are displaying the complete day's data, and not zoomed in to any specific time range.

3. To take a screenshot of your Daily screen, select one of the following:

   * For Windows or Linux: Use the F12 key
   * For a Mac: While holding down the Fn key, press the F12 key.

4.  To post an image:  https://www.apneaboard.com/wiki/index.ph...pnea_Board

[artsyuno]

Thanks. I did all that, but it won't show all of those on my screen without scrolling so it won't show them all in the screenshot. It cuts off near the top of the flow rate so it's not showing that chart.

[staceyburke]

you can resize a chart by using the mouse.  put the cursor at the bottom of the chart and hold the left mouse button and drag it up.  You can to that one chart at a time to get them to fit.

[artsyuno]

Aha! Thank you.