10-28-2017, 09:17 PM
(This post was last modified: 10-28-2017, 09:18 PM by CTcentrals.
Edit Reason: spelling
)
Users of Xylimelts and Amara View FFM
I'm wondering if any else has had similar problem and found solution/s.
The straps for the Amara View follows my mid jawline pretty close on both top and bottom and the cushion itself presses against the front teeth upper and lower.
So, two things happen: 1) the straps seem to put enough pressure on the xylimelt disk through the night that they push the xylimelt disk off its seal on my gums and it eventually ends up half-dissolved in my mouth or in the mask. I can position the xylimelt so it's not directly under the strap or cushion but movement causes it to happen, and 2) seems like there is enough pressure of strap on cheek to disc to jaw to slightly misalign and make my jaw ache a bit on whichever side I apply it. (I could be making this one up or could be tensing my jaw trying to give too much attention to situation, but wanted to check and see if anyone else had similar issue.)
Thanks!
ct
The straps for the Amara View follows my mid jawline pretty close on both top and bottom and the cushion itself presses against the front teeth upper and lower.
So, two things happen: 1) the straps seem to put enough pressure on the xylimelt disk through the night that they push the xylimelt disk off its seal on my gums and it eventually ends up half-dissolved in my mouth or in the mask. I can position the xylimelt so it's not directly under the strap or cushion but movement causes it to happen, and 2) seems like there is enough pressure of strap on cheek to disc to jaw to slightly misalign and make my jaw ache a bit on whichever side I apply it. (I could be making this one up or could be tensing my jaw trying to give too much attention to situation, but wanted to check and see if anyone else had similar issue.)
Thanks!
ct
