+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: ASV Settings (/Thread-ASV-Settings--44263)
RE: ASV Settings - birolapnea - 09-02-2024
(09-01-2024, 02:33 PM)SarcasticDave94 Wrote: Setting the mask type should be in the patient side of your setup. Change it to pillows when you swap masks.
RE: ASV Settings - birolapnea - 09-02-2024
I will use the ASV device as new. I can use manual or automatic. What risk-free settings should I make?
RE: ASV Settings - birolapnea - 09-02-2024
RE: ASV Settings - birolapnea - 09-03-2024
Let's forget about old correspondence.
In the past, there was a lot of air leakage due to the mask. I changed the mask. I will use ASV tonight for the first time. Should I use the device manually or automatically? How should I make the settings in both cases?
RE: ASV Settings - SarcasticDave94 - 09-03-2024
Changing masks or mask type would not require a full reset to your settings. If you're changing mask type, change that setting only.
RE: ASV Settings - birolapnea - 09-04-2024
THIS IS MY FIRST TIME TO USE IT. HOW SHOULD I ADJUST THE SETTINGS? BOTH MANUAL AND AUTOMATIC.
RE: ASV Settings - birolapnea - 09-24-2024
There are 2 reports. In one, AHI values and hypone counts are too low and in the other, they are too high. I always sleep in the same position. How can there be such a difference? This different image is constantly occurring. What is the reason?
RE: ASV Settings - Sleeprider - 09-24-2024
The clustering of events and much higher flow limitation on the night of higher AHI both indicate the problem is obstructive, and is likely positional. Your EPAP is fixed at 5.0 and without ASV-auto cannot respond to obstructive events as they are detected. You either need to look at positional remedies or allow EPAP to rise to mitigate obstruction.