[Product Review] Respironics "Amara View" Full Face Mask - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Product Review Forums (https://www.apneaboard.com/forums/Forum-Product-Review-Forums) +---- Forum: CPAP Mask Reviews (https://www.apneaboard.com/forums/Forum-CPAP-Mask-Reviews) +---- Thread: [Product Review] Respironics "Amara View" Full Face Mask (/Thread-Product-Review-Respironics-Amara-View-Full-Face-Mask) |
RE: Respironics "Amara View" Full Face Mask - green wings - 04-02-2016 Thanks very much for mentioning the venting problem. I had been looking at this mask, but I have a dry eye problem, too, and need a mask that vents away from my face. (03-31-2016, 07:41 PM)dawoodsman Wrote: The big problem I had was the vent design. Unlike where I think most masks are vented--to jut air flow straight away from the face--the vents on this mask sit right in front of the nose and point UP. So the air flow is washing across your eyes and forehead all night long. RE: Respironics "Amara View" Full Face Mask - pholynyk - 04-02-2016 I just brought home an Amara View mask, and examined it at the DME with this in mind. There is a roughly quarter inch square hole at the top front of the frame, but this is not the vent. It has a plastic flap behind it which gets pushed closed when the blower is operating; it is the anti-asphyxiation valve, which lets air in when the blower stops. The actual vents are the triple row of tiny holes at the front of the cushion, and they do, in fact, blow away from your face. On the other hand, if the mask isn't fitting properly, air will blow from the sides of the nose right into the eyes. Since I have a large head, we started with the large cushion, which leaked horribly. I ended up with the small cushion, and the lowest leakage I've every had last night. I have a thirty day trial, and this first night night I think I slept more soundly than ever. If this keeps up, I'm sold. RE: Respironics "Amara View" Full Face Mask - dawoodsman - 04-04-2016 Did you actually plug an amara view in pholynk? I'm going to have to differ with you, unless you have a new model where they fixed the problem. The row of holes sits on TOP of the mask, in front of the nose--as can be seen in this picture. Since they sit on top of the mask, it stands to reason the air flow cannot blow to the front, away from you. If flows up, through the holes pointing up. RE: Respironics "Amara View" Full Face Mask - JudgeMental - 04-04-2016 I think that you all are saying the same thing with just different wording of the vent locations. I have the tube attached with Velcro to the top strap so as to have it go over my head to the headboard. The exhaust vent does make the air ricochet off of the hose toward my eyes slightly. RE: Respironics "Amara View" Full Face Mask - pholynyk - 04-04-2016 I see your picture, and I'll raise you mine... [attachment=3894] The vent holes don't show up well so I stuck a needle through one of them. The vents are at the top, on the front curve of the mask, and slanting slightly up, which was a surprise to me. If you put something in front of them the air will bounce back at your face. I sleep on my sides, and haven't had that problem. I have had air leak into my eyes from around my nose, but adjusting the straps solved that problem. After three days, I am still working on adjustments, but I think it shows good promise. The holes do show up better if you click on the picture... RE: Respironics "Amara View" Full Face Mask - 0rangebear - 04-04-2016 Clarification The vent holes are on the front of the cushion as show in Pholynyk's pic. They are located just above the mask as shown in Dawoodsman's pic. So both point are correct The degree of upward ventilation is dependent on the cushion size I have tried to sizes: The small cushion the air is more upward but also deflects more upward off the upper edge of the mask. On the large cushion in vented more forward over the top of the mask edge. But when the mask seal breaks around the nose it blow upward into ones eyes on all mask sizes RE: Respironics "Amara View" Full Face Mask - dawoodsman - 04-07-2016 (04-04-2016, 02:18 PM)0rangebear Wrote: . So both point are correct The degree of upward ventilation is dependent on the cushion size Maybe there's a difference there. With the one I had, you could hold your hand on your forehead well above the mask, like you are shielding your eyes from the sun while looking off in the distance--and air would hit your hand. So air flow was flowing UP from the mask. Pholynks picture does NOT look like the mask I had--it implies they are facing forward. On my brand new mask they were definately not facing forward! I did call Phillips and they said they had no plans to change the vent design. RE: Respironics "Amara View" Full Face Mask - Sleeeppp - 05-28-2016 I started using the Amara View mask and I'm very pleased - small comfortable and no leaks.... Also, just bought a buckwheat husk pillow - took a few days to get use but worth the change. You can scrunch it up to suite the mask and sleeping positions (I sleep on my side and stomach) RE: Respironics "Amara View" Full Face Mask - 0rangebear - 05-28-2016 Sleeeppp I remember a few months back you were frustrated with a new sleep Doc. I am glad to see you finding solutions. What ever happen with the side sleeping experiment and the new Doc? (05-28-2016, 02:47 AM)Sleeeppp Wrote: I started using the Amara View mask and I'm very pleased - small comfortable and no leaks.... RE: Respironics "Amara View" Full Face Mask - Sleeeppp - 05-28-2016 (05-28-2016, 11:03 AM)0rangebear Wrote: Sleeeppp Yes - the new machine is fantastic! AHI less 1 98% of the time As expected, sleeping on my side didn't do much at all. Doc No3 not much better than the others so 'flying alone' (which isn't the best thing).... |