+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: Polarity of Pilot-24 Lite DC output? (/Thread-Polarity-of-Pilot-24-Lite-DC-output)
Pages:
1
2
RE: Polarity of Pilot-24 Lite DC output? - psteckler - 06-05-2019
(06-05-2019, 07:55 PM)kotaKat Wrote: Even the Medistrom cable offered for the AirMini most likely is just the 24VDC only.
Yes, I meant the Medistrom cable for the AirMini. The cable provided by Resmed for the AirMini is hard-wired to a wall wart.
RE: Polarity of Pilot-24 Lite DC output? - psteckler - 08-12-2019
(06-05-2019, 06:43 PM)psteckler Wrote: I'm building a power supply for the Resmed, hope it to have it built soon, and will report here.
Finally, I finished the project. Attached are pictures of the front and back.
The enclosure is much bigger than needed. I may build another, smaller one at some point, now that I know how.
The scuffing on the front is from me cleaning smeared nail polish, which I was going to use to mark the output jack. Instead, I went with a paper label.
In any case, it works!