+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: ReMed Airsense software/firmware (/Thread-ReMed-Airsense-software-firmware)
RE: ReMed Airsense software/firmware - BoxcarPete - 01-19-2024
I don't think the narrative is that sleep docs aren't knowledgeable, it's that the majority of them don't seem to make much effort to address patients' needs individually.
If you have access to the author of the source material, that's certainly more likely to yield results than the group of us going around and speculating on all of this stuff.
RE: ReMed Airsense software/firmware - Ralph436 - 01-19-2024
Well, pleasantly surprised I got an email from the author/doctor very quickly.
So that we are all on the same page this is what I wrote:
Quote:Specifically I am focused on the Resmed S-10 Autoset algorithm used to detect hypopneas shown in Table 2 of the paper.
Generally, I think I understand the the idea is to compare a ten second segment (of flow) with a previous segment (considered to be the "baseline"). If the comparison of two segments show a flow reduction of 25-50%, the segment being examined meets basic requirements to be labeled a hypopneic segment.
The specific question I have is what is the time period of the "baseline" segment.
The paper (as puiblished) might be interpreted that the baseline is just twelve seconds.
That seems to be unusually short, when compared with Respironics 60 seconds, or some medical researchers "baseline" flow of 120 seconds or more.
Is there any possibility that the 12s cited is a typo, and should actually be 120 seconds?
Her answer was that the papers (one in 2015 and one in 2022) were reviewed and approved by Resmed engineers, so as far as she knew there was no typo.
Then she went on to say that the comparison segment (reference to "baseline" ) is a sixty second rolling average (RMS) to compare the change in amplitude.
RE: ReMed Airsense software/firmware - george1945 - 01-23-2024
Has there been any follow-up on the questions?