importing from CMS50D+ to sleepyhead on mac - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum) +--- Thread: importing from CMS50D+ to sleepyhead on mac (/Thread-importing-from-CMS50D-to-sleepyhead-on-mac) |
RE: importing from CMS50D+ to sleepyhead on mac - aflynn37 - 06-15-2017 I do have the driver installed. Didn't help. Thx anyway. RE: importing from CMS50D+ to sleepyhead on mac - personal111 - 06-15-2017 Have you tried any different cables? I have problems all the time where one cable will work and another won't. Mac's can be picky. RE: importing from CMS50D+ to sleepyhead on mac - aflynn37 - 06-15-2017 Just bought a new cable that is specific to the device. No difference. RE: importing from CMS50D+ to sleepyhead on mac - Perchas - 01-20-2019 Two years have passed and no one has solved this problem. I have renewed the Apple software that had Mavericks by the Captain, I have decided to install cleanly without copying from the old one to avoid many problems if you make it migrated from the old system. I installed the SleppHead, I have loaded the data of my Dreamstation SD, configured the oximeter with its USB-UART cable and the Drivers correctly, I tested that it reads the direct data, but it starts the problems when you decide to import the CMS50D+ data. I remember that in the Mavericks it started to transfer the data when I accidentally entered the oximeter menu. SleepyHead was looking for the oximeter and says: "Oximeter Import Wizard. Select Upload Option CMS50 Scanning for compatible oximeters Connecting to Oximeter You need to tell your oximeter to begin sending data to the computer. Please connect your oximeter, enter it's menu and select upload to commence data transfer."... But that menu does not appear on the oximeter. the oximeter records the data for a maximum period of 24 hours, but I remember again and again that if you did not do it properly the data was erased and forced to record another night. Tonight I'm going to record my data and pray that tomorrow when I connect it to the Captain's iOS I can SleppyHead download the data. RE: importing from CMS50D+ to sleepyhead on mac - pholynyk - 01-20-2019 If you have CMS50D+ that has a micro USB port, it (probably) reports Firmware version 4.6. If that is the case, use must use the cable that came with the oximeter, and you must select CMS50F with version 3.7 or above. You must also have the oximeter turned on and showing the Setting Menu to keep it from turning off immediately. Hope this helps RE: importing from CMS50D+ to sleepyhead on mac - Perchas - 01-20-2019 Thank you very much, it is a response that I appreciate very much, now I understand why I did not download the data. Tomorrow I will know if it has worked |