+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Sleepyhead says I used machine only 29 minutes last night?! (/Thread-Sleepyhead-says-I-used-machine-only-29-minutes-last-night)
Sleepyhead says I used machine only 29 minutes last night?! - rnhdavis1 - 01-12-2016
I am back to using my AutoPap while my new TAP oral appliance is made. For the past two years, I've been able to get my AHI down to less than 5 with the mouthpiece. I had previously used SleepyHead and was thrilled with the information it provided and how empowered being privy to that info made me feel. So, back on the hose for a bit, I downloaded SleepyHead to my new Mac. All seemed fine until I checked out data from my first night- The data indicated I'd started my sleep session at 2 something in the AM and used the machine only 2 hours. Actually, mask and machine were in use almost seven hours, beginning at shortly before 11p. That was weird but I gave it another go last night. Today, my data indicates I only used my AutoPap for 40 some minutes, once again- at 2 in the morning. Again, I was in bed and masked up well before midnight and arose shortly after 7 AM. What could be going on? Could the card be malfunctioning? Or perhaps the AutoPap? I am confused. Previously, I'd had no issues with data import or display. I would be very grateful for anyone's insight or assistance. Thanks in advance!!
RE: Sleepyhead says I used machine only 29 minutes last night?! - eseedhouse - 01-13-2016
Check to make sure the machine's clock is set to local time.
RE: Sleepyhead says I used machine only 29 minutes last night?! - Mosquitobait - 01-14-2016
Try shutting your machine off for 5 minutes and turning it back on. Check the time. Try it one more night. If you still have a problem, your machine needs repair. This happened with my brand newbie Airsense for Her back in June. My DME replaced it with another machine, but eventually heard back that it was an electronic failure, which of course, is going to happen in a small number of machines no matter how careful the manufacturer. BUT the same fault can occur when machines get older as well.
RE: Sleepyhead says I used machine only 29 minutes last night?! - justMongo - 01-14-2016
PR machines are factory set to UTC. You cannot change it.
I only used SH about 2 years ago. So, not an expert.
I think there's a setting you in SH you need to change to define the CPAP day.