+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Flashair - new CONFIG options (/Thread-Flashair-new-CONFIG-options)
Flashair - new CONFIG options - AlanE - 04-14-2016
Flashair Dev site has posted some new CONFIG options. Some of these were available since FW 1+ and should work with W-02 and above.
[WLANSD]
ID=SMITH’S_CARD
DHCP_Enabled=YES
IP_Address=
Subnet_Mask=
Default_Gateway=
Preferred_DNS_Server=
Alternate_DNS_Server=
Proxy_Server_Enabled=YES
Proxy_Server_Name=yourproxy.com
Port_Number=8080
Enable DHCP Client (DHCP_Enabled)
Set whether to enable or disable DHCP client as follows.
YES (Default) Enable DHCP client
NO Disable DHC client
IP Address (IP_Address)
When DHCP client is disabled, set the IP Address. Default value is "0.0.0.0".
When "DHCP_Enabled=YES", values are ignored.
Subnet Mask (Subnet_Mask)
When DHCP client is disabled, set Subnet Mask. Default value is "0.0.0.0".
When "DHCP_Enabled=YES", values are ignored.
Default Gateway (Default_Gateway)
When DHCP client is disabled, set the Default Gateway. Default value is "0.0.0.0".
When "DHCP_Enabled=YES", values are ignored.
Preferred DNS Server (Preferred_DNS_Server)
When DHCP client is disabled, set the Preferred DNS Server. Default value is "0.0.0.0".
When "DHCP_Enabled=YES", values are ignored.
Alternate DNS Server (Alternate_DNS_Server)
When DHCP client is disabled, set the Alternate DNS Server. Default value is "0.0.0.0".
When "DHCP_Enabled=YES", values are ignored.
Enable Proxy Server (Proxy_Server_Enabled)
Set whether to enable or disable Proxy Server as follows.
YES Enable Proxy Server
NO (Default) Disable Proxy Server
Proxy Server (Proxy_Server_Name)
Set the domain name or IP Address of Proxy Server. Default is empty.
When "Proxy_Server_Enabled=NO", values are ignored.
Example:
Proxy_Server_Name=yourproxy.com
Proxy_Server_Name=123.123.0.1
Proxy Server Port Number (Port_Number)
Set the Port Number of Proxy Server. Default value is "8080".
When "Proxy_Server_Enabled=NO", values are ignored.
Now we can set a static IP address, subnet mask and gateway. Handy for those that have issues with DHCP assigning an IP to your card.
RE: Flashair - new CONFIG options - sonicboom - 04-14-2016
Thanks for this helpful info, AlanE
RE: Flashair - new CONFIG options - 0rangebear - 05-07-2016
Did you get the flash air to work on ResMed AirSense 10 Autoset
RE: Flashair - new CONFIG options - sonicboom - 05-09-2016
(05-07-2016, 10:43 AM)0rangebear Wrote: Did you get the flash air to work on ResMed AirSense 10 Autoset
Yes using Flash pap
RE: Flashair - new CONFIG options - kwhenrykerr - 05-19-2016
AlanE