Apnea Board Forum - CPAP | Sleep Apnea
Cropped pressure range on daily report - Printable Version

+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Cropped pressure range on daily report (/Thread-Cropped-pressure-range-on-daily-report)



Cropped pressure range on daily report - Beowulf9 - 05-13-2020

Hi - Small anomaly - Sometimes, but definitely not all the time, the pressure range (Y axis) is cropped on the daily report as per screen print below

[attachment=22888]

You will note it is capped at 10, when actual pressure range went to 15.

Thanks vm


RE: Cropped pressure range on daily report - pholynyk - 05-13-2020

If you right-click just left of the graph, by the numbers, you will open a menu that will allow you to set the range to whatever you like, plus a few other things...


RE: Cropped pressure range on daily report - GuyScharf - 05-13-2020

(05-13-2020, 08:18 PM)Beowulf9 Wrote: Hi - Small anomaly - Sometimes, but definitely not all the time, the pressure range (Y axis) is cropped on the daily report as per screen print below.

Yes, that happens occasionally and it is on our list of issues.  Interestingly, I was trying to debug that problem this morning.  But I haven't found the answer yet!


RE: Cropped pressure range on daily report - GuyScharf - 05-18-2020

(05-13-2020, 08:18 PM)Beowulf9 Wrote: Hi - Small anomaly - Sometimes, but definitely not all the time, the pressure range (Y axis) is cropped on the daily report as per screen print below

Thanks for sending your file.  This problem is fixed in 1.1.1.


RE: Cropped pressure range on daily report - Beowulf9 - 05-19-2020

(05-18-2020, 10:48 PM)GuyScharf Wrote:
(05-13-2020, 08:18 PM)Beowulf9 Wrote: Hi - Small anomaly - Sometimes, but definitely not all the time, the pressure range (Y axis) is cropped on the daily report as per screen print below

Thanks for sending your file.  This problem is fixed in 1.1.1.

Cool - thanks!