+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum)
+--- Thread: REMstar SE (/Thread-REMstar-SE)
REMstar SE - MGR - 04-07-2013
PLEASE HELP! I have a REMstar SE it is 4 buttons( ramp, left right arrow, on/button.
It came with a system one heated humidifier.
How can I change the cpap pressure. The store set it at 5 and I just finished second sleep study for titration and it needs to change to a 7. They do that at the study but the technicians did not know how to do it. Now I am stuck as I can not get appt with doctor for 6 months. Can someone help me?
RE: REMstar SE - trish6hundred - 04-07-2013
Hi MGR,
Below is a link that might help you with your machine and there are quite a few other links here on this board about it,
http://www.apneaboard.com/forums/Thread-Philips-Respironics-System-One-REMstar-SE-Machine-Help
Best of luck to you.
RE: REMstar SE - balogny - 04-07-2013
1- Put on the device (power key will ligth). Press both left arrow keys at once by 5 seconds: the message P-1 will appears. Then you will be able to walk along the full menu....To finish you must pres the power key (power ligth on) and the mesage P-0 indicates you are on the working situation.
2- - Press and hold the two left-most buttons and while still holding them, plug the AC cord into the back.
- Keep holding them until "P-1" appears (you're in programming mode when it does)
- Navigate using the right or left arrows, the icon that is lit up will show you where you are.
- Press the power button to enter the settings mode for whatever icon you're on.
(imagine the power button as an "enter" button)
- Use the right or left button to toggle up or down, press the power button to go back to "main" menu
- When you're done, keep pressing the right or left buttons until "P-0" appears
- Press power again and you're out of the settings mode...