+- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums)
+-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area)
+--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum)
+--- Thread: Viatom O2 Data Cutoff Past 12pm & Appended to Previous Day (/Thread-Viatom-O2-Data-Cutoff-Past-12pm-Appended-to-Previous-Day)
Viatom O2 Data Cutoff Past 12pm & Appended to Previous Day - R3LOADED94 - 08-12-2021
When I wake up in the afternoon my Viatom O2 data is cutoff past 12pm and this segment is shown on to the previous day but all the APAP data only goes until 12pm each day. Anyone know how to fix this?
(Zoom out)
[attachment=34684]
RE: Viatom O2 Data Cutoff Past 12pm & Appended to Previous Day - Crimson Nape - 08-12-2021
Resmed is designed to have the day change occur at noon each day, since most people don't sleep through that hour. Since your sleep sessions are going through this hour, the easiest thing to do is set the S9's clock back. The clock time is only used as a reference point for analysis and, other than the total accumulated sleep time, is not a critical factor in your therapy. There is no difference in your sleep session span (04:00-13:20 - I'm rounding) if it was reported at a different time. A 4-hour offset of 00:00-09:20, or even a 12-hour offset of 16:00-01:20, it's still the same 9 hours and 20 minutes of time.
Please note: When reading the previous times, I used the initial starting time and ending time without allowing for any breaks. These times are for reference purposes only.
- Red
RE: Viatom O2 Data Cutoff Past 12pm & Appended to Previous Day - kappa - 08-13-2021
While setting the AS10 (your profile is out of date!) time back will help to get the APAP sessions contiguous you will also have to set the Viatom clock to match, which is a little messy since you only have a 'set to current time' option in the various apps available. So you might have to set the clock on your PC (or whatever you are using) in order to change the Viatom clock.
One possibility would be to modify the o2r script to have a clock skew setting to set the clock based on current time + some offset. [ https://github.com/MackeyStingray/o2r ]