Rescan software v 5.9 - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Software Support Forum (https://www.apneaboard.com/forums/Forum-Software-Support-Forum) +--- Thread: Rescan software v 5.9 (/Thread-Rescan-software-v-5-9) |
Rescan software v 5.9 - SteveC - 09-09-2023 Hi all, I have a question re Rescan. Currently I am showing two sets of identical graphs. How to I remmove the duplicates from the display? Why would you need to display two identical graphs? Regards, Steve RE: Rescan software v 5.9 - Gideon - 09-09-2023 You cloned a chart. Simply delete one of them RE: Rescan software v 5.9 - SteveC - 09-10-2023 Hi, On the AHI chart, there is a red line on the Y axis set at 10. Is there any way to set that at 5? Regards, Steve RE: Rescan software v 5.9 - Lucky7 - 09-10-2023 Steve are you talking about the graphs at the top, because if so, I can't figure it out either. RE: Rescan software v 5.9 - Lucky7 - 09-10-2023 Added: RE: Rescan software v 5.9 - Crimson Nape - 09-10-2023 SteveC - If you are talking about the vertical red line, then if your view time is set to a larger value than your sleep session, it will not move. If you reduce the view time range from 8 hours to a value that is smaller than your sleep session, you can use the horizontal scroll bar to set the time of observation to the red line. Also, reducing the view hours will produce a turquoise (light blue?) box in the upper graphs, displaying this time window within your data that is being displayed in the lower graphs. - Red RE: Rescan software v 5.9 - SteveC - 09-10-2023 I am referring to the horizontal line on the AHI graph that starts on the Y axis at 10 (my error, it is not red, but I think magentas). I recall a sleep specialist telling me once that an AHI of 10 or below was OK, but below 5 was best. If this line could be set at 5, it would make a casual glance at the AHI graph easier. Regards, Steve. RE: Rescan software v 5.9 - SteveC - 09-10-2023 (09-09-2023, 06:41 PM)Gideon Wrote: You cloned a chart. Thanks, done |