Machine not reacting fast enough to events? - Printable Version +- Apnea Board Forum - CPAP | Sleep Apnea (https://www.apneaboard.com/forums) +-- Forum: Public Area (https://www.apneaboard.com/forums/Forum-Public-Area) +--- Forum: Main Apnea Board Forum (https://www.apneaboard.com/forums/Forum-Main-Apnea-Board-Forum) +--- Thread: Machine not reacting fast enough to events? (/Thread-Machine-not-reacting-fast-enough-to-events) |
Machine not reacting fast enough to events? - Brimstone - 04-30-2024 Hello everyone, I have been on CPAP for 2 months now and I am generally doing OK I think, but could be even better By looking at my graphs the last couple of nights I think that the pressure is not adjusting fast enough especially to hypopneas so I am getting some close to each other. Can you take a look please and give me some pointers or opinions? Thank you RE: Machine not reacting fast enough to events? - OpalRose - 04-30-2024 You will have to keep your pressure a bit higher than if you were using a ResMed machine. Also, I suggest you set the Flex level at 2. Flex doesn't give the same benefit as when using EPR (ResMed). Some folk have found that Flex set at 3 is uncomfortable, that it cuts off inhalation too early. So, I'm suggesting this change: Minimum pressure set at 9cm. Keep Maximum pressure set at 12cm. Flex set at 2. Hopefully, this will help tame some of the Hypopnea and flow limitation. Give that a try for a few days and report back with a new chart. RE: Machine not reacting fast enough to events? - Brimstone - 04-30-2024 Thank you for the advice! Will try what you suggested and see how it goes for me. |