Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

[CPAP] Why is the S9 leak always 6 liters/minute ?
#1
Question 
Why is the S9 leak always 6 liters/minute ?
Six liters per minute leak seems like quite a bit. I read that up to 24 liters/minute is okay. My mask isn't leaking, so where are these six liters per minute going ?
Post Reply Post Reply
#2
RE: Why is the S9 leak always 6 liters/minute ?
(10-24-2015, 11:00 PM)Doctor Wrote: Six liters per minute leak seems like quite a bit. I read that up to 24 liters/minute is okay. My mask isn't leaking, so where are these six liters per minute going ?
I assume, you're getting 6, from the screen sleep report as you're not using software
The S9 display 95th percentile unintentional leak (from mouth, mask, etc.), means leaks was at or below 6 L/m (not all long) for 95% of the night. If stuck at 6, might need rebooting



Post Reply Post Reply
#3
RE: Why is the S9 leak always 6 liters/minute ?
(10-24-2015, 11:20 PM)zonk Wrote:
(10-24-2015, 11:00 PM)Doctor Wrote: Six liters per minute leak seems like quite a bit. I read that up to 24 liters/minute is okay. My mask isn't leaking, so where are these six liters per minute going ?
I assume, you're getting 6, from the screen sleep report as you're not using software
The S9 display 95th percentile unintentional leak (from mouth, mask, etc.), means leaks was at or below 6 L/m (not all long) for 95% of the night. If stuck at 6, might need rebooting



Yes, 6 is on the screen but SleepyHead shows zero. Have rebooted the machine several times in the past year. I was told not to worry about the value until it exceeds 24.


Does anyone here have a leak of zero on their S9 screen ?
Post Reply Post Reply
#4
RE: Why is the S9 leak always 6 liters/minute ?
(10-25-2015, 02:20 AM)Doctor Wrote: Does anyone here have a leak of zero on their S9 screen ?

I've only ever seen that once, just after I switched to a Simplus mask. As Zonk said the leak given on the machine is the 95 percentile. It could be caused by a transitory event like your mask being nudged slightly out of place if you move in your sleep. Unless leaks are causing you problems (eg blowing into your eyes or causing face-farts) then I wouldn't worry about it.
Post Reply Post Reply
#5
RE: Why is the S9 leak always 6 liters/minute ?
(10-25-2015, 02:20 AM)Doctor Wrote: Yes, 6 is on the screen but SleepyHead shows zero. Have rebooted the machine several times in the past year. I was told not to worry about the value until it exceeds 24.

Does anyone here have a leak of zero on their S9 screen ?
S9 sleep report shows 95%
SleepyHead shows ... Min, Med, 95%, Max
Which one showing zero?
I'm not sure of the definition of Min, mine always zero

I'm not fussed about leak, as long as don't disturb my sleep or goes near my eyes
Post Reply Post Reply
#6
RE: Why is the S9 leak always 6 liters/minute ?
(10-25-2015, 03:48 AM)zonk Wrote:
(10-25-2015, 02:20 AM)Doctor Wrote: Yes, 6 is on the screen but SleepyHead shows zero. Have rebooted the machine several times in the past year. I was told not to worry about the value until it exceeds 24.

Does anyone here have a leak of zero on their S9 screen ?
S9 sleep report shows 95%
SleepyHead shows ... Min, Med, 95%, Max
Which one showing zero?
I'm not sure of the definition of Min, mine always zero

I'm not fussed about leak, as long as don't disturb my sleep or goes near my eyes



The one year of CPAP Stats on SleepyHead shows Average Leak Rate = 0.00, 90% Leak Rate 0.00, and % time above Leak Rate Threshold = 0.00 .

But the ResMed S9 screen never shows a leak rate of 0.
Post Reply Post Reply
#7
RE: Why is the S9 leak always 6 liters/minute ?
(10-25-2015, 05:41 PM)Doctor Wrote: The one year of CPAP Stats on SleepyHead shows Average Leak Rate = 0.00, 90% Leak Rate 0.00, and % time above Leak Rate Threshold = 0.00 .

But the ResMed S9 screen never shows a leak rate of 0.
I guess, its a SH problem. I cannot imagine how could be zero for everything all this time, but then I don't have much of imagination
Have you tried ResScan, but doesn't like Mac

Post Reply Post Reply
#8
RE: Why is the S9 leak always 6 liters/minute ?
(10-25-2015, 06:55 PM)zonk Wrote:
(10-25-2015, 05:41 PM)Doctor Wrote: The one year of CPAP Stats on SleepyHead shows Average Leak Rate = 0.00, 90% Leak Rate 0.00, and % time above Leak Rate Threshold = 0.00 .

But the ResMed S9 screen never shows a leak rate of 0.
I guess, its a SH problem. I cannot imagine how could be zero for everything all this time, but then I don't have much of imagination
Have you tried ResScan, but doesn't like Mac



Good point, Zonk. Thanks Will try ResScan.
Post Reply Post Reply
#9
RE: Why is the S9 leak always 6 liters/minute ?
Interesting!!! I just looked at my leak rate statistics in Sleepyhead. What caught my interest was the fact that my average leak rate is 1.49 for the last 6 months and 1.43 for the last year. My 90% leak rate is 0 for the last 6 months and 0 for the last year. I do not think that this is mathematically impossible but it is mathematically improbable I think.

Frankly, I seldom look at the statistics in Sleepyhead.

Best Regards,

PaytonA

Admin Note:
PaytonA passed away in September 2017
Click HERE to read his Memorial Thread

~ Rest in Peace ~
Post Reply Post Reply
#10
RE: Why is the S9 leak always 6 liters/minute ?
Sounds like an issue with the Sleepyhead and the S9. Mine seems to read okay.

6-months
ALR: 7
90% LR: 15.4
Using FlashAir W-03 SD card in machine. You can download your data through wifi with FlashPAP or Sleep Master utilities.

I wanted to learn Binary so I enrolled in Binary 101. I seemed to have missed the first four courses. Big Grinnie

Stick it to the man, Download OSCAR and take back control of your data!

Thanks Ian. Like I didn't have enough Honey-Do projects to tackle. Mornincoffee
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Yet another Large Leak help request apneavolt 6 400 11 hours ago
Last Post: SarcasticDave94
  [Treatment] Acceptable AHI with worrying minute ventilation / tidal volume McRiver 20 652 12-17-2024, 08:21 PM
Last Post: meraa
  Mouth leak Pablo1985 2 250 12-09-2024, 05:56 PM
Last Post: Pablo1985
Sad [Treatment] Weird Flow Rate/Minute Vent OK Laptop 3 769 12-04-2024, 03:15 PM
Last Post: Jay51
  OSCAR Leak Rate Question AndyB 5 515 11-13-2024, 10:45 AM
Last Post: Epark617
  Leak issues, should I try a different mask before 30 day trial ends? Epark617 13 631 11-12-2024, 08:06 PM
Last Post: Epark617
  [CPAP] Does this new user have leak issues? clarkage 2 297 11-07-2024, 05:42 PM
Last Post: clarkage


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.