Hourly pressure record?
My sleep therapist changed my RresMed Airsense 11 mode to ``autoset'' a few days ago. He used the pressure limits of 5 to 20. It was formerly fixed (cpap mode) at 13. During the night I find that the pressure seems to hover at the low end of the range. I would like to see an hourly pressure record, but can't figure out how to display this record on OSCAR---if it is even possible. Could someone tell me how do do thisd? Thanks.
RE: Hourly pressure record?
Look at the Pressure and Time at Pressure graphs on the Daily screen.
- Red
RE: Hourly pressure record?
(07-21-2024, 12:15 PM)Crimson Nape Wrote: Look at the Pressure and Time at Pressure graphs on the Daily screen.
- Red
Thanks for your response. On the daily screen, the right side is blank except for a statement the `there is no data to graph.' And the pressures stats on the left side read zero.
RE: Hourly pressure record?
Did you have your SD card in while sleeping?
Also, be sure the graphs are actually selected. Look at the drop down box, bottom right of daily page.
RE: Hourly pressure record?
(07-21-2024, 01:28 PM)OpalRose Wrote: Did you have your SD card in while sleeping?
Also, be sure the graphs are actually selected. Look at the drop down box, bottom right of daily page.
Graphs are turned on, but you might have solved the problem. I did not have the card in---just put it in to dump the data. I'll put it in and try again tomorrow.
Thanks so much.
07-21-2024, 01:58 PM
(This post was last modified: 07-21-2024, 01:58 PM by SarcasticDave94.)
RE: Hourly pressure record?
Yep, to get detailed info, the SD card needs to be in the CPAP first before it captures data. After the fact gets you a summary.
Mask Primer
Positional Apnea
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
RE: Hourly pressure record?
With your help I have been able to export the pressure graphs from my machine, but now I have an interpretation question: Why do I have two graphs for pressure (different colors, same axes). They do show slightly different results. I have looked at the guide, but there is a lot of info there and I haven't been able to find it. Thanks for any help.
RE: Hourly pressure record?
(07-22-2024, 12:37 PM)Heaviside Wrote: With your help I have been able to export the pressure graphs from my machine, but now I have an interpretation question: Why do I have two graphs for pressure (different colors, same axes). They do show slightly different results. I have looked at the guide, but there is a lot of info there and I haven't been able to find it. Thanks for any help.
you use pressure relief (EPR) ? if so one graph should be epap (the lower one) and the other ipap.
