Problem with FlashPAP and FlashAir

[Crimson Nape]

OK, I got bored and ran tests on the same data using FlashPAP as the transport.  My card is about 25 feet away from the AP.  I ran two tests on each setting, one with noise canceling set to 0 and then set to 1.   Here are my results:


.  .  . no animals were harmed during these tests.  

[AlanE]

Not bad. No one but us geeks would appreciate that though


and you have way too much time on your hands man.. get a hobby.

[mogulman]

Interesting. So noise cancel helps with N, but hurts with G. Strange.

[mogulman]

Are the TX/RX, actual throughput, or reported speed?

[Crimson Nape]

The Tx and Rx were sampled during a data download. Otherwise they go to 1 / 26.

[RobertWA]

Thanks all for your help.  I finally got it all working.

Robert

[mogulman]

OK, I got bored and ran tests on the same data using FlashPAP as the transport.  My card is about 25 feet away from the AP.  I ran two tests on each setting, one with noise canceling set to 0 and then set to 1.   Here are my results:


.  .  . no animals were harmed during these tests.  

Hmm..so I was going to try Noise Cancel on my unit, but then I went to the developers guide and it shows that Noise_Cancel=2, is the correct setting.  So putting a 1, isn't actually doing anything other than the default right?
https://flashair-developers.com/en/docum...ISE_CANCEL

[Crimson Nape]

Thanks!  I guess I was thinking in binary.  I'll give it another try later.