Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Resvent iBreeze error "Turbine running abnormally"
#1
Resvent iBreeze error "Turbine running abnormally"
   

I have been using the resvent iBreeze 20A machine with Resmed Airfit F20 mask for the past three months.

Everything seemed to be working ok. My AHI went down from almost 60 before therapy to less than 5 every night with the machine.

Two days ago, I woke up around 5am by a repeating, loud, sharp beep. As if a bomb was about to go off. I thought it might have been one of those amber alerts from my phone but that wasn't the case. Then I noticed the screen of my iBreeze machine had a message: "System error code:212. Turbine running abnormally. Please reboot the device. Contact your supplier if the error still exists". I was too sleepy to deal with this, so I unplugged the device from my power and slept for a few hours without the mask.

When I woke up, I tried to connect the machine (which caused it to reboot in the process). The screen came up normally. Then I tried doing the "mask fit". Instantly, the error message came up and machine started beeping loudly.

So I rebooted the machine again. Let it sit without power for the rest of the day. In the night, I restarted it, wore my mask, and started the normal operation. It seemed to work for about three minutes, and then the dreaded message and the beeping tone again.

I am attaching the image of the message.

Anyone have a similar experience or know what might be the cause or the solution?

Thanks
Post Reply Post Reply
#2
RE: Resvent iBreeze error "Turbine running abnormally"
Hi bedroomsinger!  -  Welcome
All the blowers in the CPAPs, that I'm aware of, have microprocessors connected to monitor voltage, run time and rpm for feed back to be used with the pressure sensor.   I'm not sure what is causing your problem, but as new as it is, it is still under warranty.  Have you contacted your supplying DME about this problem?  If not, I'd make it my first call Monday morning.

Please keep us informed as this plays out.

- Red
Crimson Nape
Apnea Board Moderator
Project Manager for OSCAR - Open Source CPAP Analysis Reporter
www.ApneaBoard.com
___________________________________
Useful Links -or- When All Else Fails:
The Guide to Understanding OSCAR
OSCAR Chart Organization
Attaching Images and Files on Apnea Board
Apnea Helpful Tips

INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#3
RE: Resvent iBreeze error "Turbine running abnormally"
I'm also getting a 201 error. What I've found is water/moisture in the machine when I remove the humidifier. If I tip it to where the humidifier is down water runs out. Once the machine dries out - it works again. Have had minimal trouble since I turned down my humidity level and am very careful about how full I fill the humidifier tank. Haven't tried leaving the humidity level set high and removing the tank when I shut the machine off.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  How to keep two Resmed Airsense 10s running when power turned off? TwoSleepy 8 455 10-28-2024, 03:45 PM
Last Post: TwoSleepy
  Error Message GUI Lib Invalid from Dreamstation 2 amybinaz 5 441 10-21-2024, 12:56 PM
Last Post: rkreiple
  Resmed S9 Autoset an error message after changing the motor SealL30 5 1,139 10-06-2024, 10:45 PM
Last Post: Rickyricardo
  AS11 not running or collecting data? slatejetpack 2 279 09-25-2024, 05:40 AM
Last Post: slatejetpack
  React Luna G3 - Error 85 SMWinnie 0 168 09-15-2024, 10:50 AM
Last Post: SMWinnie
  DreamStation cellular modem (info on troubleshooting 1-0 error code) soyjer 2 393 09-01-2024, 01:46 PM
Last Post: soyjer
  Resetting the motor error message on a ResMed 10 stagebuilder 7 1,624 08-15-2024, 04:51 PM
Last Post: chronic


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.