I've just been given a Resmed s9 for a week after I did a sleep survey. I got 52 aps per hour. I noticed the machine is set up for nasal mask but I have been given a full face mask. Will this make any difference?
Ta
Hello Guest,
Welcome to Apnea Board !
S9 setup
|
10-03-2015, 01:50 PM
S9 setup
Hi,
I've just been given a Resmed s9 for a week after I did a sleep survey. I got 52 aps per hour. I noticed the machine is set up for nasal mask but I have been given a full face mask. Will this make any difference? Ta
RE: S9 setup
Since this is only a temp machine that you will be using for 1 week, it is my opinion that it really won't matter. When you get your permanent machine next week you can select the right mask. If it concerns you, you can get the clinician's manual and set the proper mask. The link is at the top ^
Using FlashAir W-03 SD card in machine. You can download your data through wifi with FlashPAP or Sleep Master utilities.
I wanted to learn Binary so I enrolled in Binary 101. I seemed to have missed the first four courses. Stick it to the man, Download OSCAR and take back control of your data! Thanks Ian. Like I didn't have enough Honey-Do projects to tackle.
10-03-2015, 02:03 PM
RE: S9 setup
It really should be set for the type mask being used. The machine uses this information to estimate vent rate; and it may figure into the apnea scoring algorithm which uses a sonar like technique to look at reflected wave to determine if an apnea is obstructive or open airway. Admin Note:
JustMongo passed away in August 2017
Click HERE to read his Memorial Thread ~ Rest in Peace ~
10-03-2015, 02:15 PM
RE: S9 setup
Hi Johnnysinc,
WELCOME! to the forum.! It probably would be a good idea to set your machine to the right mask setting. Hang in there for more answers to your question and much success to you with your CPAP therapy.
trish6hundred
RE: S9 setup
(10-03-2015, 01:50 PM)Johnnysinc Wrote: Will this make any difference?Depend on the model, whether AutoSet, Elite, Escape Auto or Escape All looks the same, but the Escapes are different as night and day in comparison to the other two Elite is data capable fixed pressure machine, Autoset is data capable too but does both ways, fixed and variable (2 machines in 1) Escape is a lemon, Escape Auto is APAP but still a lemon ResMed newer machine "AirSense 10" [should say "AutoSet, AutoSet for Her, Elite or CPAP"]
10-03-2015, 05:33 PM
RE: S9 setup
Mask setting should be set to patient.
Tap the settings button (it looks like it has two check marks on it). Turn the big knob to select mask type. Tap the silver part of the big knob. The mask type line should now be blue (or is it orange it changes to?) Turn knob to select the right type of mask. Tap knob to confirm selection. It will change color again. Done
PaulaO
Take a deep breath and count to zen.
10-13-2015, 04:16 AM
RE: S9 setup
Thanks for the replies. I asked about it at the clinic and it's pretty much as justMongo says. I have now been given an s9 elite with humidifier that's been set to 17. Now to deal with the farting mask and strap marks.
10-13-2015, 05:48 AM
RE: S9 setup
(10-13-2015, 04:16 AM)Johnnysinc Wrote: I have now been given an s9 elite with humidifier that's been set to 17. Now to deal with the farting mask and strap marks.You've my sympathy, not easy but can be done You'll need SleepyHead to have an idea of what is going on and to point to any concern might have with your doctor at the next follow-up Good luck
RE: S9 setup
Which Quattro mask do you have?
Admin Note:
PaytonA passed away in September 2017 Click HERE to read his Memorial Thread ~ Rest in Peace ~
10-14-2015, 02:34 AM
RE: S9 setup
It's a quattro full facemask. When it ramps up to 17 it wants to lift off my face. Strapping it tighter helps with the leaks but leaves my face a mess. I had to take it off halfway through the night last night as my face was too sore. It seems like the seem material is too pliable and struggles at the higher pressure. Any recommendations?
|
« Next Oldest | Next Newest »
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
Micham Therapy Thread Setup Aircurve 10 CS PaceWave | micham | 14 | 227 |
2 hours ago Last Post: micham |
|
New CPAP User - Lofta Results & DreamStation Setup | cruzazul86 | 6 | 170 |
01-16-2025, 01:10 PM Last Post: cruzazul86 |
|
Tech Nerds-think this battery setup will work for Transcend Micro? | johnbrain | 15 | 1,996 |
10-08-2024, 05:21 PM Last Post: Phaleronic |
|
initial aircurve pacewave setup | cexer | 34 | 1,849 |
06-22-2024, 12:05 PM Last Post: SarcasticDave94 |
|
NEW MEMBER INFO: GET YOUR OWN [secret] CPAP SETUP MANUAL | SuperSleeper | 1 | 2,865 |
05-25-2024, 01:18 PM Last Post: SuperSleeper |
|
Smallest travel CPAP setup w/ Transcend Micro | kotaKat | 5 | 3,242 |
04-02-2024, 11:44 PM Last Post: johnbrain |
|
Interference from battery charger in DC battery backup setup? | Daxvex | 3 | 553 |
01-22-2024, 11:59 AM Last Post: Daxvex |