Hello Guest,
Welcome to Apnea Board !
/
Settings going from Dreamstation to ResMed
|
Settings going from Dreamstation to ResMed
|
veloracer
Posts: 15 Threads: 6 Joined: Mar 2021
Machine: dreamstation
08-11-2021, 05:40 PM
Settings going from Dreamstation to ResMed
Current Dreamstation settings - no ramp, 9 to 10.5 , flex 2.
Is there a rule of thumb for how to set up the ResMed 10 auto set based on those dream station settings? Thanks. 
Gideon
Wiki Editor 
Posts: 12,828 Threads: 295 Joined: Dec 2016
Machine: ResMed Aircurve 10 VAuto
08-11-2021, 06:29 PM
RE: Settings going from Dreamstation to ResMed
A guess
7-11, EPR=2 full time For better advice, based on data, post your OSCAR daily charts
Gideon - Project Manager Emeritus for OSCAR - Open Source CPAP Analysis Reporter
Download OSCAR OSCAR - The Guide New to Apnea? Helpful tips to ensure success Soft Cervical Collar Mask Primer Dealing with a DME Organize Charts Optimizing Therapy
veloracer
Posts: 15 Threads: 6 Joined: Mar 2021
Machine: dreamstation
08-11-2021, 06:35 PM
RE: Settings going from Dreamstation to ResMed
Here is some older Oscar data. All I have on my phone. But been pretty consistent. Thanks.
Dog Slobber
Posts: 423 Threads: 5 Joined: Mar 2018
Machine: Resmed AirCurve 10 VAuto
08-11-2021, 07:13 PM
RE: Settings going from Dreamstation to ResMed
Pressure
I would set the same minimum and maximum settings, but be prepared to lower the maximum if you have an aversion to higher pressures. Then looking at OSCAR data prepare to gently increase maximum as you acclimatise. EPR/Flex ResMed's EPR is measured in CM, Respironics Flex is more like a Low/Medium/High with high being about 2CM. Having said that, I would still set EPR to the same as Flex, but be prepared to drop down a notch. Response ResMed's are considered by many to be more responsive. This translate to faster and potentialy greater pressure increases. Setting the response rate to Soft can give the ResMed a more similar feel to your DreamStation.
koala1
Posts: 126 Threads: 6 Joined: May 2021
Machine: Airsense 10
08-11-2021, 09:46 PM
RE: Settings going from Dreamstation to ResMed
(08-11-2021, 06:29 PM)Gideon Wrote: A guess Second this settings. Lower min pressure works well for me on Resmed after I switched from DS. Some adjustments may be required afterwards but it’ll be good starting point.
Phaleronic
Posts: 806 Threads: 25 Joined: Jun 2019
Machine: Remediated Dreamstation APAP-CPAP Mode
08-11-2021, 10:26 PM
RE: Settings going from Dreamstation to ResMed
I needed more pressure at min when moving to the S10, I also can't handle the for her setting if it's the version with that setting..
SarcasticDave94
Posts: 14,432 Threads: 21 Joined: Mar 2017
Machine: None again
08-11-2021, 11:04 PM
RE: Settings going from Dreamstation to ResMed
Use the same settings Gideon mentions but feel free to use the standard AutoSet mode instead of For Her. Shouldn't be much of an issue in choosing either mode with that setup.
Mask Primer
Positional Apnea INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Gideon
Wiki Editor
Posts: 12,828 Threads: 295 Joined: Dec 2016
Machine: ResMed Aircurve 10 VAuto
08-11-2021, 11:23 PM
RE: Settings going from Dreamstation to ResMed
I was assuming standard AutoSet
Gideon - Project Manager Emeritus for OSCAR - Open Source CPAP Analysis Reporter
Download OSCAR OSCAR - The Guide New to Apnea? Helpful tips to ensure success Soft Cervical Collar Mask Primer Dealing with a DME Organize Charts Optimizing Therapy
veloracer
Posts: 15 Threads: 6 Joined: Mar 2021
Machine: dreamstation
08-12-2021, 06:14 AM
RE: Settings going from Dreamstation to ResMed
First night data with ResMed. Upped the starting pressure since it seems to low. Have ramp off but just noticed SmartStart is on - not sure what that is. Not a great nights sleep (work insanity) but AHI of .47. Anyone see anything glaring I should adjust?
Thanks.
Gideon
Wiki Editor
Posts: 12,828 Threads: 295 Joined: Dec 2016
Machine: ResMed Aircurve 10 VAuto
08-12-2021, 09:22 AM
RE: Settings going from Dreamstation to ResMed
Can't argue with success
How do you feel?
Gideon - Project Manager Emeritus for OSCAR - Open Source CPAP Analysis Reporter
Download OSCAR OSCAR - The Guide New to Apnea? Helpful tips to ensure success Soft Cervical Collar Mask Primer Dealing with a DME Organize Charts Optimizing Therapy
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
|
[Pressure] New User: Help w/ Optimal Settings for ResMed AirSense 11 with Airfit N20 Nasal Mask | textureofthings | 12 | 403 |
Yesterday, 01:29 PM Last Post: SarcasticDave94 |
| [Treatment] BIPAP Settings - ResMed AirCurve 11 Vauto | dcbauman | 20 | 881 |
12-17-2024, 03:42 PM Last Post: Sleeprider |
|
| New to Resmed Aircurve 11 ASV, need help with settings | gcoll | 2 | 246 |
12-14-2024, 10:37 AM Last Post: Sleeprider |
|
| Going from Dreamstation to ResMed 11... I don't want to lose any data | jimcaffey | 4 | 255 |
11-22-2024, 08:12 AM Last Post: SarcasticDave94 |
|
| Help with ASVAuto ResMed AirCurve 10 settings (and esophageal pain) | RowG | 2 | 257 |
11-17-2024, 08:34 AM Last Post: RowG |
|
| Help with Resmed 11 Settings | underoathtdwp | 2 | 353 |
10-23-2024, 11:58 PM Last Post: underoathtdwp |
|
| Transfer Dreamstation Go Settings. | txrpls | 0 | 146 |
10-22-2024, 07:53 AM Last Post: txrpls |
|
/
Settings going from Dreamstation to ResMed
