Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.
Login or Create an Account
Another thought: Might it be worth increasing Min EPAP while also increasing PS to improve comfort? (I'm still a total newb, but that's my initial thinking after reading the device manual.)
You can edit both up 1, probably no negatives there. Another item? Have you trialed Trigger very high? Trigger is known and proven to assist in lowering CA. Maybe trial that a bit and see if it helps.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Changing settings to find the most comfortable settings is something I fully endorse. The only caveat is you should change one variable at a time or it will get confusing what is helping or not.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Haven't shared an update in a while, as I've been traveling and dealing with a pesky cold, so my sleep has been atypical. But I'm back home and almost over my cold so I wanted to check in again.
A while back I changed to trigger Very High and have been satisfied with that change, as it's greatly reduced CAs.
I've been fiddling around with min/max/PS to try and optimize my sleep, and I'm not sure where to go from here. I'm attaching the last 2 nights of sleep, Dec. 1 & 2. I increased max and PS after the first night and was surprised to see that events went up rather than down after making those changes. Shouldn't it be the opposite, or am I misunderstanding? Or perhaps I just need to give it more time. Would love to hear your thoughts.
I think it may be an example of having a set of data bits where you had low to high settings, and having seen the results, you've probably sampled too low, too high, and Goldilocks just right (or close). AKA turn back PS to 6. Maybe then afterwards pressure itself.
This is assuming the first of these two OSCAR shots represent your middle ground just right ish. Since the higher settings were worse, you can likely consider just prior to be in the middle ground. Caveat is it's single day samples that we're seeing here.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
