Can someone give an opinion on these results ?

[Gideon]

My first choice to limit Max pressure is to limit the cause.  In this case it is flow limits and your EPR, which is the best tool to manage it is not yet maxed out at 3.

[CPAPfriend]

hey Gregsleep

I think there is a lot of good feedback in this thread. Just going to second to not tighten your mask too much, to try adjusting it, clean it, shave/trim your beard if you have one, switch masks. Let us know which troubleshooting steps you decide to go with first and update us here! Keep in mind that a poor mask seal is among the most common reasons for PAP non-compliance, so just hang in there; there's lots to try.