Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

How to clean your Resmed AutoSet 10 heated hose?
#1
How to clean your Resmed AutoSet 10 heated hose?
Can you immerse the entire heated hose in water even with the special connector? Reading the manual seems to suggest you can?
Post Reply Post Reply
#2
RE: How to clean your Resmed AutoSet 10 heated hose?
Yes, I've been immersing the entire hose for years with no problems. I dunk it in a basin of hot soapy water, slosh it back and forth a few times then drain it. I then run very hot clean water through it to flush out the soap, and hang it up to dry.
Post Reply Post Reply
#3
RE: How to clean your Resmed AutoSet 10 heated hose?
Just for a little cheap insurance against oxidation of the connector tabs, the electrical ones on the male end of the hose, I would dab at all their visible surfaces with a Q-Tip dipped in isopropyl alcohol.  It is hydroscopic and will absorb all the water, which, as you probably are aware, is an enabler for oxidation if it is the least bit acidic.  Or, purchase a small can of electrical contact cleaner and give them a short blast once every five or eight cleansings after you have finished rinsing them under water and the water has evaporated apparently.

I have even gone to rubbing the visible contacts with a clean, freshly scrubbed (on your jeans), pencil eraser.  This works wonders to restore contacts on cordless phones as well, BTW.  Even the side of a rubber band will do in a pinch.  The rubber will scrub off oils and contaminants and some of the oxidation, much of which is not always visible.

Again, you needn't do this as often as you swish and rinse the hose.
Post Reply Post Reply
#4
RE: How to clean your Resmed AutoSet 10 heated hose?
I completely immerse my hose, slosh the water around in it, dump the water, repeat and then rinse in hot water. I use an air mattress inflater to blow air through the base to dry it out.
Useful Links
Download OSCAR
Organize your OSCAR and SleepyHead charts
Attaching images and files to posts


Advisory Members serve as an "Advisory Committee" to help shape Apnea Board's rules & policies. Membership in the Advisory Members group does not imply medical expertise or qualification for advising Sleep Apnea patients concerning their treatment.
Post Reply Post Reply
#5
RE: How to clean your Resmed AutoSet 10 heated hose?
(01-24-2019, 02:18 AM)DeepBreathing Wrote: Yes, I've been immersing the entire hose for years with no problems. I dunk it in a basin of hot soapy water, slosh it back and forth a few times then drain it. I then run very hot clean water through it to flush out the soap, and hang it up to dry.

^^^^^^ What he said!  Well-done
Post Reply Post Reply
#6
RE: How to clean your Resmed AutoSet 10 heated hose?
An easier approach is to not wash it at all. I've never found mold or growth in my hoses after I stopped washing them.
Download SleepyHead
Organize your Sleepyhead Charts
Posting Charts
Beginner's Guide to SleepyHead
Mask Primer
5
Advisory Members serve as an "Advisory Committee" to help shape Apnea Board's rules & policies.

Membership in the Advisory Members group does not imply medical expertise or qualification for advising Sleep Apnea patients concerning their treatment.



Post Reply Post Reply
#7
RE: How to clean your Resmed AutoSet 10 heated hose?
What's the old saying?

An ounce of prevention is worth more than a pound of cure.  Big Grin
Post Reply Post Reply
#8
RE: How to clean your Resmed AutoSet 10 heated hose?
Clean up time for my CPAP/ASV equipment involves Dawn dish liquid and very warm water. Soaking about half hour. This does include full immersion of the heated hose. Let all parts air dry for 4 hours or more. My cleaning intervals vary a bit, but roughly it's been between monthly and quarterly-ish.

Coffee
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEBSITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#9
RE: How to clean your Resmed AutoSet 10 heated hose?
I was recently hospitalized with a preliminary diagnosis of pneumonia. Later, I googled "does using a CPAP increase the risk of pneumonia?" Turns out, it does. (I did NOT have pneumonia, I did have sepsis! Not at all related to CPAP use.)

A member of the hospital staff said to get a bucket with a close-fitting lid and put hydrogen peroxide (H2O2) and water in a 1:1 (equal parts) ratio and immerse the mask, hose, and humidifier chamber in the solution overnight. Rinse with hot water and hang to dry. Do this once a week and alternate the parts, one set soaking, rinsing, drying; one set on the machine. I wash my mask every day with soap and water, so I'll probably leave the mask out of the mix.

The H2O2/water solution can be used multiple times. Just put the date of the compounding on a card, when I've used the solution 4 times, make new solution. 

I came here to find out if immersing the heated hose would be okay. Yes, it is! And found other great stuff, including the "eraser on the metal contacts" piece. THANKS!

I'm all set to try this new cleaning regimen. Even though I didn't have CPAP-related pneumonia, I do want to clean, clean, clean that humidifier and hose. As the hospital staff person said, we like to breathe warm, moist air and bacteria love that, too! Hydrogen peroxide gives a knock-out punch.
Post Reply Post Reply
#10
RE: How to clean your Resmed AutoSet 10 heated hose?
I have to admit, the longer I'm doing this (CPAP Therapy) the more relaxed I am about it. It'll be 6 years in mid Sept.

I don't worry all that much about the hose anymore. I tend to focus on the mask. It gets a good cleaning about once a week or so. I use some Clorox anti-bacterial wipes between a good dunking in hot water and dish soap.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  airsense 10/11 aircurve 10 heated tube only eok361 0 91 11-19-2024, 11:30 PM
Last Post: eok361
  Resmed Climateline Vs Oxy Hose Akeyla 8 688 11-15-2024, 07:31 PM
Last Post: StuartC
  Dreamstation heated hose temp repair fix Corvette817 12 4,393 11-12-2024, 01:56 PM
Last Post: Beenie Bay
  should I use cpap pressure over autoset Person 35 1,992 11-05-2024, 12:51 PM
Last Post: Dormeo
  Heated tube hevy6 6 509 10-31-2024, 10:53 AM
Last Post: WallyPepper
  [Equipment] Brand new machine prompting to change mask, hose, filter ttsoldier 2 214 10-21-2024, 11:56 AM
Last Post: ttsoldier
  Airsense 10 Autoset Too Much Pressure? MiRock72 14 795 10-16-2024, 08:48 PM
Last Post: MiRock72


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.