Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

hose sliding off mask
#11
RE: hose sliding off mask
Thanks to all for your thoughts on this small problem! I now have some ideas to address it. Thus far, I've tried Ren's idea of carefully washing the inside of the Climateline hose end that attaches to the mask elbow with warm water and detergent, then carefully drying it. I was careful to avoid getting any water around or past the orange sensor. The washing did make a difference; the hose again grabs the elbow pretty firmly.
Post Reply Post Reply
#12
RE: hose sliding off mask
(01-15-2013, 03:42 PM)zonk Wrote: my 2 years old hose does that but the new one is tight fit
if sleep om my left side facing machine, the weight of the hose as dangle down can pull the hose off
but it does not come off when sleep on my right side facing the other way

also make sure the swivel grey piece which attach to the elbow is not missing or stuck in the other hose

I wash the climateline and other hoses in hot soapy water and hook to kitchen hot water tap to flush and rinse out and hang to dry a day or two
I do have spares but don,t like throw the old one if can be used

Post Reply Post Reply
#13
RE: hose sliding off mask
(01-17-2013, 03:03 PM)zonk Wrote: if sleep om my left side facing machine, the weight of the hose as dangle down can pull the hose off
problem solved
cushion placed near the edge of the bed prevent the hose from coming off

Post Reply Post Reply
#14
RE: hose sliding off mask
(01-20-2013, 10:39 PM)zonk Wrote:
(01-17-2013, 03:03 PM)zonk Wrote: if sleep om my left side facing machine, the weight of the hose as dangle down can pull the hose off
problem solved
cushion placed near the edge of the bed prevent the hose from coming off

Sign of genius: answering your own questions on a public forum. BigwinkGrin
SuperSleeper
Apnea Board Administrator
www.ApneaBoard.com


INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.


Post Reply Post Reply
#15
RE: hose sliding off mask
(01-21-2013, 11:24 AM)SuperSleeper Wrote: Sign of genius: answering your own questions on a public forum. BigwinkGrin
just one my flaws .... I talk to myself a lot
cannot be helped ... at times, it does shows



Post Reply Post Reply
#16
RE: hose sliding off mask
(01-21-2013, 03:01 PM)zonk Wrote: just one my flaws .... I talk to myself a lot

At least you have someone intelligent to talk to. Coffee
SuperSleeper
Apnea Board Administrator
www.ApneaBoard.com


INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.


Post Reply Post Reply
#17
RE: hose sliding off mask
(01-15-2013, 06:45 PM)TheDuke Wrote: I use my hoses for a long time, and have also experienced the problem of stretched hose cuffs coming loose. The very easy solution is to get  automotive hose clamps for both ends and gently clamp the hose on. Any auto supply place (Advance, O'Reilly, etc.) has these clamps quite inexpensively. My preference is for worm drive clamps since that affords an excellent control of applied pressure on the hose coupling.

TheDuke

Hi Duke. Your solution is great if you have clearance around the hose for the screw on the clamp. However, I didn't and brainstormed. 

In my case, I need to first put a rubber seal on the machine's plastic air outlet so the hose can grab on and not slip off. I came up with putting on an unlubricated condom and cutting a hole across it. I'll let you know if it works. 

If anyone knows why I shouldn't try this, e.g., damage to me or the machine, please let me know.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Loose hose fix SleeplessInVirginia 2 142 12-16-2024, 11:23 PM
Last Post: Deborah K.
  Resmed Climateline Vs Oxy Hose Akeyla 8 783 11-15-2024, 07:31 PM
Last Post: StuartC
  Dreamstation heated hose temp repair fix Corvette817 12 4,504 11-12-2024, 01:56 PM
Last Post: Beenie Bay
  [Equipment] Brand new machine prompting to change mask, hose, filter ttsoldier 2 253 10-21-2024, 11:56 AM
Last Post: ttsoldier
  ResMed Airsense 11 heated hose buggy285 6 550 09-28-2024, 08:18 PM
Last Post: Big Guy
  P10 nasal 15mm connected to 19mm hose? Stubert 2 298 09-25-2024, 01:06 PM
Last Post: Stubert
  [Equipment] overnight cover: machine, hose and mask? seepapnyc 9 509 09-15-2024, 01:25 PM
Last Post: seepapnyc


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.