Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.
Login or Create an Account
Machine: ResMed Airsense 10 Mask Type: Full face mask Mask Make & Model: Respironics Dreamweave Humidifier: Resmed CPAP Pressure: 6 min, 10 max CPAP Software: OSCAR
myAir
Other Software
04-09-2024, 04:28 PM (This post was last modified: 04-09-2024, 04:37 PM by dharris01.)
Do I need to tweak my numbers
[attachment=62453][attachment=62452][attachment=62453][attachment=62453][attachment=62452][attachment=62452]I've been on APAP since last Oct, 2023. I'm not sure if I am getting the best results from my APAP therapy. I use a RESMED 10 Airsense with a Respironics Dreamwear Full Face Mask. My pressures are set a 6 min and 10 max.
My sleep test AHI was 21. My min and max pressures were set during an overnight titration study.
I very rarely sleep more than 2-3 hours, when I first go to sleep. I will wake up, and then go back to sleep and sleep for another 2-4 hours.
While my AHI numbers have usually been below 5, my flow limitations seem high. I also usually have a lot of RERA's. Not sure if that is a concern or not. During my overnight sleep titration session I had a ton of leg movements; but have not been diagnosed with restless leg syndrome.
I am attaching 3 days of Oscar charts for review. Please let me know if anyone has any suggestions on how I can possibly improve my therapy.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Machine: ResMed Airsense 10 Mask Type: Full face mask Mask Make & Model: Respironics Dreamweave Humidifier: Resmed CPAP Pressure: 6 min, 10 max CPAP Software: OSCAR
myAir
Other Software
(04-09-2024, 06:16 PM)OpalRose Wrote: Ok, a few changes. Flow Limitation and Reras are too high and may be disrupting sleep. You will need EPR to help lower that.
Set minimum to 7cm ( you may need 8), with maximum set at 15cm.
Set EPR to 3 (full time).
Machine: ResMed Airsense 10 Mask Type: Full face mask Mask Make & Model: Respironics Dreamweave Humidifier: Resmed CPAP Pressure: 6 min, 10 max CPAP Software: OSCAR
myAir
Other Software
I set the pressures - 7 cm min, 15 cm Max with EPR on full time at 3. my numbers are good, but I had trouble sleeping. I believe a main part of that is my worrying about the numbers - lol.
The Apnea you see at the beginning of therapy is probably SWJ (sleep-wake-junk),
which can be happen between that sleep and awake phase, or simply just you worrying over your numbers.
The few CA's are not anything to worry over. We all get those occasionally.
Give this a couple days to settle down, and try to relax. As stated above, sometimes is just trial and error. But don't judge by one day.
Report again in a couple days, we'll take another look.
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Machine: ResMed Airsense 10 Mask Type: Full face mask Mask Make & Model: Respironics Dreamweave Humidifier: Resmed CPAP Pressure: 6 min, 10 max CPAP Software: OSCAR
myAir
Other Software
04-15-2024, 03:12 PM (This post was last modified: 04-15-2024, 03:13 PM by dharris01.)
RE: Do I need to tweak my numbers
Here are my OSCAR charts from Apr 11 - 14. I was out of town during those days, so I was not able to post these until I returned today. I did not change the timezone settings in my ResMed 10, so the times are an hour off. I went from the Central Standard Time Zone to the Eastern Time Zone. I don't believe that that affected the charts.
The new settings appear to be working great. No (zero) RERA's and much lower flow limitations during this time frame.
OSCAR charts for Apri 14th.