SleepyHead not showing leak data

[rem52]

I have a ResMed A10 CPAP brick, which I am trying to change...

In comparing ResScan 5.5.0.9xxx and SleepyHead v0.9.8-1 data,
I can see where ResScan is showing leak data from 0 to 39.6.
However SleepyHead is not showing any leak data at all.

Is this a feature due to the brick value of my machine or a bug?

[AlanE]

It's possible Sleepyhead won't read the data properly because of the machine. I also wouldn't rule out a bug. Which version of Sleepyhead are you using?

[rem52]

SleepyHead v0.9.8-1

[AlanE]

My bad, you *did* say what version SH you were using in your first message.

I wouldn't have much hope of trying to get SH to work with your machine. The importer for it was (most likely) not done because it is a brick. I would stick with ResScan until you change out the machine. ResScan is still very useful. In my opinion, for what that is worth.

[rem52]

ok thanks