Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.
Login or Create an Account
I've been using my ResMed AirSense 11 with an AirFit N30 mask for about 10 months now and I can't seem to dial in the settings. Sometimes I would get around 3 AHI but usually no better. Any advice?
Your pressure settings are off. Your starting pressure of 4 is mostly for small children. I suggest that you raise it to 8, and raise your upper limit to 12. I think things will be better for you.
Machine: Remediated Dreamstation APAP-CPAP Mode Mask Type: Full face mask Mask Make & Model: Airfit F20 Humidifier: Built In CPAP Pressure: CPAP 15cmH2O CPAP Software: OSCAR
Welcome to the forum Shinky, you're have CAs along with the other events, you can leave it on 4cm min for now but turn EPR off please, EPR really needs much higher pressure.
Machine: REMstar System One with Autoflex Mask Type: Full face mask Mask Make & Model: Quattro AirFit F10 Humidifier: yes typical setting = 1 CPAP Pressure: 10.5-14.5 APAP with AFlex x1 CPAP Software: SleepyHead
EncoreBasic
just looking at your actual chart, you snore and have OAs at times that correlate to flow limitations. Those occurances are predominantly at pressures of 7.0 and below. So, you really have good evidence that the minimum pressure would make sense somewhere above 7.0. Certainly you willl benefit by increasing that minimum, and 8.0 as Deborah K. suggests is not outrageous and a good start.
