Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

What else causes flow limits?
#1
What else causes flow limits?
Since the folks in here pointed out that I have an issue with flow limits, I first tried adjusting the EPR in line with suggestions. This didn't seem to help the flow limits but did increase my centrals.

 I then tried a cervical collar with EPR back to 'normal'. A bit of fiddling was required to adjust the fit so that it prevented chin tucking while allowing me to mouth breathe. I eventually got to the point where I could sleep with it all night but alas, flow limits are unchanged once again.

I have attached last night's graphs, one showing the flow limits and one is a zoom in on the breath waveform.

Can anybody tell me if this degree of flow limitation is indeed a problem that needs addressing and, if so, what else I could try please?

[Image: bRZZoxL.png]


[Image: itLIlXI.png]
Post Reply Post Reply
#2
RE: What else causes flow limits?
You have some flattening of the sine wave during inspiration in that chart. I would raise min pressure to 12.4cm.
Post Reply Post Reply
#3
RE: What else causes flow limits?
FLs disturb the sleep of some people and not others, so it's hard to know in advance if it'd help you to reduce them. Also, they can originate in the nose or further down in the airway. If they originate in the nose, there's really nothing the machine can do to fix them. The structures in the nose are too rigid.

So my question to you would be whether you have a stuffy nose or other nose-related problems. Or perhaps you breathe through your mouth during the night? That would rule out a nose-related FL issue.

Also, in your place I would increase the EPR to 3 and leave it there for at least a week to see whether it tends to help with FLs. I wouldn't worry much about the CAs; they may very well decrease on their own as your body adjusts to the EPR.
Post Reply Post Reply
#4
RE: What else causes flow limits?
Folks here can better help you if you change your Oscar charts. Eliminate the calendar and the pie chart. Then we can see useful information below. Also, on your first page, we need to see the following, in the order listed, and nothing more:

Event Flags
Flow Rate
Pressure
Leak Rate
Flow Limits

We need to be able to read to the very bottom of the flow limits.
Machine:  ResMed AirCurve 10 Vauto
Mask:  Bleep DreamPort Sleep Solution
Post Reply Post Reply
#5
RE: What else causes flow limits?
This reply is to subscribe to this thread concerning flow limitations.  I don't see a button to click for subscribing so reply posted.
I only give suggestions from experience as a fellow CPAP user, not professional advice.
Post Reply Post Reply
#6
RE: What else causes flow limits?
If you click on the thread you wish to subscribe to, look at the very lower left corner of the thread's end, right below the "Possibly Related Threads..." section. There is the option to subscribe to that thread.
- Red
Crimson Nape
Apnea Board Moderator
Project Manager for OSCAR - Open Source CPAP Analysis Reporter
www.ApneaBoard.com
___________________________________
Useful Links -or- When All Else Fails:
The Guide to Understanding OSCAR
OSCAR Chart Organization
Attaching Images and Files on Apnea Board
Apnea Helpful Tips

INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT.
Post Reply Post Reply
#7
RE: What else causes flow limits?
Turning the question around, do you feel the flow limitations are something that needs addressing? You have a 95% of 0.12, which is 2.2x what we like to see (95% FL=0.05). If it is not affecting your sleep, then it is less of a problem.

Having some flattening of inhalation waveforms is not unusual for most. Even those with a “perfect” night will have some flattening. 

Given the limitations of your machine (EPR=3 is the max), you can likely clean up quite a bit by increasing EPR from 2 to 3 as has been pointed out. However, I doubt it will solve it completely. Even with a bilevel and EPR of 4 or more you will have some flattening of inspiration peaks. The question is how much does it affect your sleep?

Have you seen an ENT to get your airway checked? Could be anything from enlarged turbinates to deviated septum to something else.
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Stuffy Nose - Flow Limitation? mark.apnea 3 248 11 hours ago
Last Post: radarrab
  Expiratory Flow Limitation? deebob 4 152 Yesterday, 03:35 PM
Last Post: Dormeo
Sad [Treatment] Weird Flow Rate/Minute Vent OK Laptop 1 619 11-28-2024, 09:08 AM
Last Post: ChadBSr
  Help Needed with CPAP Flow Chart Interpretation HijolG 19 1,049 11-23-2024, 03:25 PM
Last Post: HijolG
  Flow Limitations? gr3gg0 13 673 11-23-2024, 11:12 AM
Last Post: SeePak
Exclaimation [CPAP] Increased EPR reduces flow limits even when EPAP is simultaneously decreased G. Szabo 5 466 11-16-2024, 09:16 PM
Last Post: SeePak
  EPR 1, hight flow limit, but lots of CA throwaway1242 13 876 11-15-2024, 07:30 PM
Last Post: OpalRose


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.