09-24-2023, 08:18 AM
Resvent iBreeze 25STA error code: 609
I've had this BiPAP for approximately 1 1/2 years, having been affected by the Philips recall. The machine has been functioning normally until this morning. After returning from the bathroom around 5AM, I restarted my therapy and the pressure was very high. When I turned it off, it displayed the following error message:
"System error code: 609, Abnormal pressure detected. Check the water tank is assembled correctly. Contact your supplier if error still exists."
I followed the instructions. There seemed to be no issue with the water tank. There was no moisture outside of the tank noted inside.
After that, I disconnected the power for about 30 seconds and tried it again. The pressure was still abnormally high. I then disconnected the power for about 30 minutes and when I restarted it again, it seemed to be functioning normally. I will contact my supplier tomorrow but wanted to see if anyone has experienced this issue as well.
Thanks in advance for any input.
"System error code: 609, Abnormal pressure detected. Check the water tank is assembled correctly. Contact your supplier if error still exists."
I followed the instructions. There seemed to be no issue with the water tank. There was no moisture outside of the tank noted inside.
After that, I disconnected the power for about 30 seconds and tried it again. The pressure was still abnormally high. I then disconnected the power for about 30 minutes and when I restarted it again, it seemed to be functioning normally. I will contact my supplier tomorrow but wanted to see if anyone has experienced this issue as well.
Thanks in advance for any input.
