S9 Autoset says it's reading SD card when I remove it

[saltydawg2]

In the last week, I have not been able to update sleep results. When I put it into Oscar, it says data already up to date. I then noticed that my machine was saying it was reading SD upon removing it. I tried re formating a couple of different cards, with no difference. Any ideas?

[Crimson Nape]

I would check and see if you have the Write-Protect turned on.

[Ratchick]

My ResMed 10 warns me if the write protect is on so I would see what that says. Is there anything ON the formatted card, after you run it for a few minutes? It should be writing data to it.

When you say "reading SD on removing it" do you mean that when you return it to the ResMed it says that for a few seconds before returning to the menu? Or is it still saying that before you eject it (or while ejecting it)?

[saltydawg2]

The write protect is off. As I take it out of the slot, it says Reading SD card. Usually when I put it in, there is no reaction. Sometimes when I put it in, it tells me reading SD card, but says that for at least 15 minutes. Sometimes the resmed logo comes on, the green on button flashes once, and then shows the resmed logo again, and repeats.

[Crimson Nape]

Do you have another SD card to try?

[SarcasticDave94]

Maybe the SD card slot is going buggy.

[saltydawg2]

I've tried a couple of cards I had, after re formating them. The slot COULD be acting funny, but no way to test it. I've had it since 2014, so I could likely get a new one. As explained in another ongoing thread, I am trying to set an appointment with a pulmanologist, to determine if I need a different machine, due to CA jacked. Just hate to think I can't monitor anything.