Internal Power Connector AirSense 10

[Sleeprider]

Call Supplier #27 who is an authorized repair facility. The CEO has been a member on this and other forums, currently inactive. They might sell you the part. http://www.apneaboard.com/forums/Thread-...9#pid98309 HE self-identifies in this post

[terrycts]

The best I can tell it is a 4 amp - 24 volt power jack connector.   There is a 2.1x5.5 DC power jack on Digi-key.  Its P/N is: 486-3380-ND and sells for a $1.64.

Also, here is a PDF listing of the most common power jacks, https://cdn.sparkfun.com/datasheets/Prot...-028-1.pdf

I hope this helps.

The P/N you listed is not it, but I think the common power jacks pdf includes the jack. Problem is I want the custom part which would also include the board. Used is OK.

---

Call Supplier #27 who is an authorized repair facility. The CEO  has been a member on this and other forums, currently inactive. They might sell you the part.  He http://www.apneaboard.com/forums/Thread-...9#pid98309  self-identifies in this post

I will follow up on this on Monday. Thank you!

[Crimson Nape]

I read your post above immediately after I created the previous post. The board that you refer to is more than likely a Resmed manufactured design. I've gone back and measured my power supply plug and have found that the one that I listed above isn't correct. My power plug measures 7.3 mm OD with a 5.0 mm ID and a recessed pin that I am unable to measure. I will continue to look for a replacement. I'm sure someone else will be needing this in the future.

[terrycts]

I read your post above immediately after I created the previous post.   The board that you refer to is more than likely a Resmed manufactured design.  I've gone back and measured my power supply plug and have found that the one that I listed above isn't correct.  My power plug measures 7.3 mm OD with a 5.0 mm ID and a recessed pin that I am unable to measure.  I will continue to look for a replacement.  I'm sure someone else will be needing this in the future.

[Crimson Nape]

I came across this little tidbit on Wikipedia :
OD: 7.4
ID: 5.5
Pin Dia.: 0.5
Barrel Length: 12.5
Used on: Some Asus, Dell, HP, Sony laptop computers; Dyson hand-held vacuum cleaners

I guess they need to add Resmed 10 series to that list.

[Moseby]

Not sure if you're still following this forum but it would be great to know if you ever tracked down the part you needed?