Reading data from the sd card
Hi, im a very new user (6 days) and only discovered this board today.
I was using resmed myair to look at my results but then read about sleepyhead on here so downloaded that.
My problem is that my pc wont read my sd card at all, all other cards i have work fine as soon as i put them in the reader but my resmed one just does nothing.
Is there anything else i need to install?
Thanks
12-22-2015, 04:10 AM
(This post was last modified: 12-22-2015, 04:13 AM by big_dave.)
RE: Reading data from the sd card
Any SD card reader should be able to do the job. Either the ResMed SD card is corrupt, or you have some weird compatibility issue between the card and the reader. If you have another blank SD card, you can try to see if the machine will recognize it. Then, either use that card, or else use your computer to reformat the ResMed card.
You can also try using a different SD card reader. They're cheap.
You may also have a malfunctioning machine that's not capable of using SD cards. If this turns out to be the case, you will want to get a warranty replacement.
RE: Reading data from the sd card
The machine has been sending results to myair no problem so i presume it is working ok.
Its also set up where it sends results straight to my doctor so reluctant to start formatting etc in case it messes all that up. Its the doctor that has supplied the machine so i will ask on my next visit on the 31st dec. I have to take the sd card with me then so i presume he will be looking at the results then.
RE: Reading data from the sd card
On the off chance, look at the SD card and see if the little tab on the side is pushed to the write-protect position. . .Just a guess.
RE: Reading data from the sd card
Did you push it in all the way on the PC?
Some are spring loaded and you need to push it all the way in, and it will make a "click" sound. Then push it in again to remove it.
Others you push in until it stops, but there is no "click".
You should see it appear in your PC's "Explorer" window as another disk drive. If not, there's something wrong. You can try re-booting your PC.
RE: Reading data from the sd card
The SD card does not send data to my air or your doctor. The data that is sent to my air and your doctor is the limited data the machine stores and then sends by modem.
Happy Pappin'
Never Give In, Never Give Up
INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. ALWAYS SEEK THE ADVICE OF A PHYSICIAN BEFORE SEEKING TREATMENT FOR MEDICAL CONDITIONS, INCLUDING SLEEP APNEA.
RE: Reading data from the sd card
(12-22-2015, 04:00 AM)colpac Wrote: Hi, im a very new user (6 days) and only discovered this board today.
I was using resmed myair to look at my results but then read about sleepyhead on here so downloaded that.
My problem is that my pc wont read my sd card at all, all other cards i have work fine as soon as i put them in the reader but my resmed one just does nothing.
Is there anything else i need to install?
Thanks
I wonder if the problem is that your computer's SD card reader is simply too old. Your SD card is almost certainly an "SDHC" card (more than 2Gb in capacity). Very old SD card readers cannot read these cards due to changes in the interface specification. In some (very few) cases, a new device driver might fix this, but I'd say that's a very unlikely case.
RE: Reading data from the sd card
Hi colpac,
WELCOME! to the forum.!
Much success to you with your CPAP therapy.
trish6hundred
RE: Reading data from the sd card
(12-22-2015, 04:00 AM)colpac Wrote: Hi, im a very new user (6 days) and only discovered this board today.
I was using resmed myair to look at my results but then read about sleepyhead on here so downloaded that.
My problem is that my pc wont read my sd card at all, all other cards i have work fine as soon as i put them in the reader but my resmed one just does nothing.
Is there anything else i need to install?
Thanks
I am a new user too, (2 days) and downloaded sleepyhead. Inserted Resmed SD card into my computer and it does not even see the card, same as you. Card is locked as suggested. Sleepyhead cannot find any data. Have you found any solution?
Thanks.
Inspired
RE: Reading data from the sd card
(01-13-2016, 11:26 PM)Inspired Wrote: I am a new user too, (2 days) and downloaded sleepyhead. Inserted Resmed SD card into my computer and it does not even see the card, same as you. Card is locked as suggested. Sleepyhead cannot find any data. Have you found any solution?
Thanks.
How old is your computer? If you have other SD cards, do they have the "SDHC" logo on them? Are they more than 2Gb in capacity?
Before 2006, SD cards (and the readers in computers) were limited to 2Gb capacity. In 2006 the SDHC spec was released and newer cards with higher capacities are implemented to this spec. Older computers that only support SDSC cards cannot read SDHC cards without an adapter - typically a small device that accepts an SD card on one side and plugs into a USB port on the other side.