Hello Guest, Welcome to Apnea Board !
As a guest, you are limited to certain areas of the board and there are some features you can't use.
To post a message, you must create a free account using a valid email address.

or Create an Account


New Posts   Today's Posts

Tech Nerds-think this battery setup will work for Transcend Micro?
#11
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
Go it to work with 19v trigger cable
Post Reply Post Reply
#12
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
(04-02-2024, 11:43 PM)johnbrain Wrote: Go it to work with 19v trigger cable

How long did you get it last for on the anker 24000mah battery bank?
Post Reply Post Reply
#13
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
(10-05-2024, 04:03 PM)juwoods Wrote: How long did you get it last for on the anker 24000mah battery bank?

Two nights. Not sure what happened third night but it drained. I think it slipped off a little so it was drawing more. Overall I'm happy with the setup. Ifmonlymi could find a right angle barrel adapter instead of the straight one if have.
Post Reply Post Reply
#14
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
Quick reply...
In my experience a cpap machine use just shy of 100Wh per night. I've measured this with both my machines (Resmed Airsense 10 Auto en Resmed Airsense 11 Auto) no heated tube, no humidifier running.
I have several 12 volt batterypacks. The Chinese 88.8 Wh set won't make it through the night. And yes, I've measured how much energy went in during charging.
Interestingly, it doesn't really matter if you use a small inverter to mains voltage (200 Watt or smaller) or a buck/boost converter (12 v to 24 v DC). Both use about the same amount of energy per night. The buck/boost converter is significantly smaller and lighter, but it can only run the cpap machine. The inverter can run just about everything small that uses mains voltage.
Just one warning. If you are going for the inverter, make sure you use a true sinewave inverter. Anything that says modified sine wave is likely to fry your electronic stuff.

If you need to get a battery, get at least 150 Wh of energy, preferably a bit more, per night. Your battery will loose some of its capability over time, so take that into account.

Cheers,

Charan
Post Reply Post Reply
#15
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
Yeah on paper it shouldn't, but I'm pretty confident it drained my 200wh camper batteries. Well that combined with some other 12v stuff overnight.
Post Reply Post Reply
#16
RE: Tech Nerds-think this battery setup will work for Transcend Micro?
I've used my group 32 deep cycle marine/rv battery for 3 nights without a charge using my humidifier and machine (DS1) without an issue and it has around a 50 percent charge left...
Post Reply Post Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Operating CPAP with battery.... Ulrika 46 33,199 11-30-2024, 11:13 PM
Last Post: Crowleyal
  Piecing together a deep cycle battery solution - solar and house power Crowleyal 6 236 11-29-2024, 06:30 PM
Last Post: Crowleyal
  Battery backup question PaulaO2 20 1,065 11-28-2024, 06:40 PM
Last Post: Tampa Jim
Question Struggling with VPAP - Meeting Sleep Tech tomorrow! JRC81 10 389 11-25-2024, 02:29 PM
Last Post: SarcasticDave94
  ResMed P10 vs. F&P Nova Micro Nasal Pillows Deborah K. 2 366 11-19-2024, 06:26 AM
Last Post: SeePak
  HDM Z1 Battery Replacement Ephraim 14 6,280 11-14-2024, 02:59 PM
Last Post: SteveB260
  [Equipment] Need advice for battery gennadyd 10 517 11-13-2024, 07:16 PM
Last Post: Polo 1955


New Posts   Today's Posts


About Apnea Board

Apnea Board is an educational web site designed to empower Sleep Apnea patients.