Using OSCAR after migration of data

[nadprok]

The instructions for using OSCAR after the first time state that you should highlight the desired profile and press the "Select User" button .
When I highlight my profile there is no "Select User" button anywhere on that page . If I click on the profile nothing happens . However if I double click on the selected profile the data loads and the Welcome page comes up . I have no problem downloading from my SD card in this fashion but I was wondering if I might have done something wrong in the initial migration . How would I correct this ?

[jaswilliams]

The instructions for using OSCAR after the first time state that you should highlight the desired profile and press the "Select User" button .
When I highlight my profile there is no "Select User" button anywhere on that page . If I click on the profile nothing happens . However if I double click on the selected profile the data loads and the Welcome page comes up . I have no problem downloading from my SD card in this fashion but I was wondering if I might have done something wrong in the initial migration . How would I correct this ?

In file =>preferences you can select open last used profile on startup there is no select user button the button is Open Profile


In preferences => Appearence

Under graph settings make sure on opening switch tabs is set to Welcome this will ensure OSCAR launches the welcome page after opening, you can set othe options but that’s the setting I use

[nadprok]

jaswilliams : Thanks for the advice . That solves my problem .